Here I am

Search Results for Query: *

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. T

    Engine/Transmission (1994 - 1998) NV4500 to G56 conversion kit

    The issue is really that 1st gear is to tall. Some of our drivers will slip the clutch to much when pulling the trailer out of the water and up the boat ramps. (We build and set boat docks) The gearing on our 05 and 06 G56/3. 73 trucks is perfect. Our thinking is that with the 96 12valve, G56/4...
  2. T

    Engine/Transmission (1994 - 1998) NV4500 to G56 conversion kit

    Also read posting below. 1st gear is to tall on the nv4500 The oldest truck in our fleet is a 96 12 valve/NV4500 C/C that is dedicated to hauling @15,000 lbs on secondary roads. It has only 30k miles on it, but the clutch is gone. I would like to find a complete NV4500 to G56 conversion kit...
  3. T

    Super Chips Engine Tuner

    What about Edge Product's Juice w/Attitude, or A2?
  4. T

    Quiet, but good flowing exhaust

    Ward, last week end I installed a Donaldson M085171 on my truck in my garage. I only have 25miles driving as I have been busy this week with work :{ but I noticed that the idle sound is quite, the air filter clog indicator pulled in a lot less, the turbo seemed to spool up faster, the water...
  5. T

    Exhaust(ing)... I'm thinking about a Geno's MEK

    Walker, I just replaced my stock muffler with one from Donaldson, PN M085171. The installation required a short piece of straight pipe from the cat back to the new muffler, and I rewelded the factory hangers on the new muffler and pipe. The installation was clean and straight foward, did...
  6. T

    Which exaust for no drone?

    Forrest, do you know what the Donaldson Muffler part number is that you used is? I am looking to start working on my truck.
Back
Top