Here I am

Search Results for Query: *

  • Users: Nuka
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. N

    Engine/Transmission (1998.5 - 2002) 01 died while at idle, any ideas???

    she's running checked lp press while cranking, 10psi changed fuel filter bled vp44 cracked 3 injecters and bled same then it eventually started to fire while cranking it. Bottom line is it did run out of gas at idle in my drive way while showing a quarter of a tank on the gauge. Thanks...
  2. N

    Engine/Transmission (1998.5 - 2002) 01 died while at idle, any ideas???

    it is possible, but not for at least a week now as I am back to work. :(
  3. N

    Engine/Transmission (1998.5 - 2002) 01 died while at idle, any ideas???

    Lift pump Sorry I overlooked your earlier ques. up to this point I am still using the original lift pump. . Still havn't bled injectors or installed my px gauge. Just not enough time with kids and xmas so close. Thanks for the continuing info.
  4. N

    Engine/Transmission (1998.5 - 2002) 01 died while at idle, any ideas???

    Codes?? Just used a snap on Solas to get the codes. the only one it had was p1693. P1693 Mil Fault ion companion Mode. Not sure what that translates to. .
  5. N

    Engine/Transmission (1998.5 - 2002) 01 died while at idle, any ideas???

    thanks Thanks for the input. I'm going to work on it starting Wed. I'll let you know what I find. Codes. . don't know yet. temp... 19F Fuel. . added 10 gallons to make sure, no start Gelling?? never have had it, run Power service in every tank religiously, plus fuel is thinned here in...
  6. N

    Engine/Transmission (1998.5 - 2002) 01 died while at idle, any ideas???

    I know the hole lift pump saga, however I haven't had any troubles with my stock 01. 5 with 70000 miles on it and then today my wife started it to pre heat it and went back out 10 min. later to load the kids and it wasn't running and won't start now. Turns over fine and has 1/4 tank of fuel. Any...
  7. N

    Engine/Transmission (1998.5 - 2002) '01 oil press sending unit FAILED AGAIN.....

    Jim I just got it changed about an hour ago. Went for a short test drive and it appears to have done the trick. My original was pretty big as far as the diameter of the wrench flats. It took a 1 1/4" deep socket to get the original one out, but the replacement was a 1 1/16 which i bought a...
  8. N

    Engine/Transmission (1998.5 - 2002) '01 oil press sending unit FAILED AGAIN.....

    Jim I'm having the same problem, however i got a new sender from my local Cummins dealer and it is P/N 4921511. There have been several numbers that superceed each other but supposedly this is the one we need. Good luck Joe 01 dodge
Back
Top