Search Results for Query: *

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. J

    Front Ball Joints: While I'm in There???

    If you do not have lockout hubs, front axles and differential, and front drive shaft spin all the time you are driving. What else gets lubed in 4WD?
  2. J

    Cummins 2.8l TurboDiesel Crate Engine

    Here is my 1971 with a 4BT.
  3. J

    Cb and Ham radios

    I use an older version of the Cobra 75 All Road Wireless CB Radio - Dual-Mode AM/FM All the controls are on the handset.
  4. J

    cool air on driver side, warm to cool on passenger side

    The charge is low. Freon flow path through the evaporator cools the driver side first without enough cooling left for the passenger side. I have to do it occasionally due a small leak in my AC system. I use the procedure and the bands below in the chart to add to existing charge. I get...
  5. J

    cool air on driver side, warm to cool on passenger side

    I use the procedure and the bands below in the chart to add to existing charge. I get satisfactory results without evacuating the system. A/C PERFORMANCE TEST WARNING: REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE FOLLOWING OPERATION. FAILURE TO FOLLOW THE...
  6. J

    Good ball joints?

    Ditto on EMF! Good Joints, good value. Use High moly (5%) grease in them. Grease that meets the Caterpillar pin and bushing specs will work. I use this: https://www.schaefferoil.com/238-ultra-supreme.html
  7. J

    2005 48re OD button/ Tow-Haul

    Yes. It changes shift points and converter lockup behavior for better towing performance.
  8. J

    Engine bearing advice?

    Have the oil analyzed at the next oil change, it will tell you what is going on with the engine internals. I use Blackstone Laboratories. Sample kits are free, the analysis is $30.00 if you send in the sample for analysis. You can sample through the dipstick tube if you want the analysis...
  9. J

    A/C Pressure too high.

    I use the procedure and the bands below in the chart to add to existing charge. I get satisfactory results without evacuating the system. A/C PERFORMANCE TEST WARNING: REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE FOLLOWING OPERATION. FAILURE TO FOLLOW THE...
  10. J

    Needing a new alternator

    Brand and purchase location? My alternator is at 270K miles.
  11. J

    New Batteries

    Just replaced mine. Interstate tech recommended MTP-65HD to get 850 CCA, and that is what I bought. Replaced my last Interstate batteries because they were 5 years old and I noticed a little slower cranking as the weather cooled. Interstate dealer gave me a little money on the purchase...
  12. J

    Need a Part # for Mopar PREMIUM brake pads

    I do not think it, here are the facts: 1. The slots in the disk surface “clean” the pad in the braking phase, regenerating the friction material, removing debris or glaze. Downside, pads may not last as long. 2. The slots disrupt the layer of water on the disk when driving in the rain. The...
  13. J

    Need a Part # for Mopar PREMIUM brake pads

    You are not convincing me. You are correct that slotted rotors are not needed in normal conditions. But, when the gray haired lady pulls out in front of you in her 1985 Buick, I want all the advantages I can get. Loads of information available on the benefits of slotted rotors that contradict...
  14. J

    Need a Part # for Mopar PREMIUM brake pads

    No, I do not get it yet, explain it to me. Slotted rotors provide better braking performance for several reasons, improving safety. Period.
  15. J

    Need a Part # for Mopar PREMIUM brake pads

    NASCAR tracks are full of cars that "fell for the hype"
  16. J

    Need a Part # for Mopar PREMIUM brake pads

    Slotted rotors provide additional performance if you do heavy towing. If you do not tow and just drive the truck around, Use standard rotors to save money.
  17. J

    Ball Joint Press Accessories

    I used a press like yours on the first side I did and ran into some problems with length during removal and installation but was able to finish by rearranging the rings and plates. For the second side I bought this from amazon. I bought this one because it has two screws of different...
  18. J

    Need help 06 5.9 4x4

    My story is similar. My son and I had finished installing his newly rebuilt engine into his 2006 2500. When we went to start it it would not crank. We had been very careful recording disconnects and reconnects. Voltage checks for a couple of hours and found no discrepancies. We asked the...
  19. J

    the right stuff

    I use Zerex Heavy Duty Extended Life coolant mixed with distilled water in all my diesels. https://www.valvoline.com/en/zerex-extended-life-antifreeze/
Back
Top