Search Results for Query: *

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. G

    No voltage to AC compressor

    Well you all were right as usual, clutch went out, TIPM shut down. New compressor and reset TIPM all is good!
  2. G

    Alternator voltage 14.5

    Well I didn't mean to start a fire here. ECU/ECM/PCM/ all refer to something I can't fix or adjust. However reading back over many old posts it seems 14.5+- at the batteries with my fluke meter is normal. I appreciate the help.
  3. G

    Alternator voltage 14.5

    Thanks for the reply. How do I create a signature with all my info? 2007 5.9 stock. BTW my scan tool shows target voltage 14.8. reading the older thread shown all of them have 14.5 to 15v. I guess I'm just old fashioned, looking for 13.8 to 14.2 like the old days.
  4. G

    No voltage to AC compressor

    Thanks for the tip, unfortunately 2007 so TIPM controls. I'll trace the wire back from the compressor.
  5. G

    No voltage to AC compressor

    No AC, freon ok, AC button lights up when pressed. Dealer says need new compressor but when I checked, there was no voltage to clutch. Is there a fuse somewhere?
  6. G

    Alternator voltage 14.5

    Alternator voltage is at 14.5 both on the gauge and at the battery. Dealer said I need a new alternator but this one charges fine, just too high voltage. Both Batts are new. Can the PCM be adjusted or does it need replaced (ouch).
  7. G

    Reliable rear end service east tenn

    Looking for a replacement source or rebuilder near east tenn for a 11.5 AA sure grip rear end. Pulled the hubs looking for growling source but no joy, small seal leak but bearings are perfect. Ran it with axles out and noise is there.
Back
Top