Search Results for Query: *

all clips went in after removing plastic plugs under needle bearing cap

has anyone else had a problem with the plastic plugs that are under the needle bearing cap.the worn out set had these and one gallery would not get grease,two needle bearing sets one in each joint was rusty.also i could not compress the needle bearing caps enough to get the second half moon clip...

thats comming soon .i am still on original clutch 350,000 kms and counting.

it could be, my truck has original clutch the pedal gets pushed in and out for 12 years and 336,000 kilometers.the metal pin the clutch arm pivots on has wear you can see and feel.anyway the shifts are much easier.i might buy a prefilled hydraulic unit from rock auto to complete this fix until I...

the video to remove this is on you tube .look up '2005 dodge 3500 clutch master/slave cylinder replacement'.it shows how to remove pin/bushing.its by perfection clutch

actuator pin at pedal pics of parts are up. thanks for reply

clutch actuator arm pin/bushing and pedal Aarm bushings one new one old

hi, recently my nv 5600 was getting growly.hard to get in gear ,stop and go was a lot of grinding.any way the pedal had a loy of back and forth and side to side play.i pulled the big white pin that goes through the actuator rod and it had a groove about 1/8 of an inch on the push side.i phoned...

Thank you ,my aftermarket manual had nothing useful on this.

does any-one know the torque for the top idler pulley bolt