Search Results for Query: *

Good Idea Moine drives me nuts bouncing around all the time I thought about putting tape over it and check it when I suspect a problem.

My Air Dog constantly gives me different pressures even in the summer. Right now it is in the 20's and I get 14psi at idle if I'm lucky and 11-12psi under way. Not How It was advertised. Although Until It drops below 10psi I'll deal with it.

Thanks for the info I'll give it a shot.

I Lost the wiring instructions to my bd noise filter,. Can anyone help? Looked around here but there seems to be different opinions and I would like to see the instructions. Orange with blue stripe or black with orange and if black with orange is it on the middle connector or the engine side...

Bad news , as many of you probably suspected no lockup again. Weighing my options for a fix. I'm creeping up on 200,000 mi so I guess I've gotten all I can out of the stock transmission. Money is tight so I'm gonna take her for ll shes got. I'll take it easy and keep from towing anything for now...

Thanks for the responses, sorry I did not respond sooner. Well I had a friend pull the pan at his shop due to my taking off for a little fun in the snow and this is how it stands. He found a snap ring in the pan from who knows where. He hooked up the scanner and found that the pcm was powering...

Took off this morning after usual warmup routine and no lockup in od. Was fine last night with no possible cause in mind. Have read a little and am leaning toward od/lockup solenoid, any suggestions before I drop the pan. Any help would be appreciated as I am supposed to be leaving in the am for...

That was me, going to or from my brothers in Tolland.

Losing pressure but no fluid loss. Pumping pedal will build pressure enough to shift but holding to the floor the truck will start to creep. The truck owner depends on this truck and would rather just change the whole assembly and only have the truck down once. What are you thinking? Mike

I am looking for new clutch hydraulics and was wondering what folks have used and how much I should expect to pay? I have read threads where guys have claimed to have paid under $200 for a complete pre bled setup but Have not been so lucky getting prices. The truck is a 2000 6 speed. Any help...

Howes! Haven't had a problem yet with two trucks without preheaters

I also installed the fp-100. I have been happy with it for the most part but have a pressure fluxuation problem i cannot pin down. But this seems to be a very uncommon problem.

Any chance you changed your drums also? I have had new drums so untrue they made the truck shake violently.

How about output shaft speed sensor? Also known to cause this problem.

pc Thank you my last reply was sent before i saw your response

y I have to replace the gasket under the long intake plate itself so i was just curious. I did get the two small gaskets for the horn and heater as well but thought the plate on the bottom would need torq. Thanks for the infO

Blew an Intake gasket and was wondering what the proper torque on the bolts was before I replace the gaskets.

I added the quad about two months ago and no change until today. I will check the cable. I do remember my 12v would not hit od/lockup until 50mph like clockwork. This 99 has always shifted at 40-43 mph. Strange, I'll see what happens in the morning. Thanks

Let me start by saying that I always noticed my tc lockup slightly over 40 mph on the speedo. Today on my way home after about 30 min of driving I noticed that all of a sudden the tc was not locking up until almost 50 mph. Is this a sign of anything about to happen? What may be causing this? I...

I have a complete Farmall B if anyone is interested. I wouldn't mind selling it. Very similar to the A. I believe the engine is the same.