Search Results for Query: *

  • Users: WRLIVE
  • Content: Threads
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. W

    Service 4wd question

    My 'Service 4wd' light on the dash is illuminated almost everytime I go to drive the truck. I checked the condition of the wiring and plugs on the transfercase and everything looks good. I replaced the motor on the transfercase which did not fix the problem. The truck still goes into 4wd thank...
  2. W

    New Turbo installed - What should I expect?

    Hey guys, I just got my Super B installed along with the new BD exhuast manifold. Everything seems to working fine. Truck drives just as it did before. I've got a hundred and some miles on it at this point and there is no wow factor. Are my expectations skewed? If I stand on it my display...
  3. W

    Just took delivery of my new 48RE

    Hey guys, I'm gearing up to swap my 48RE, TC, and flex plate and would like to know what tips and tricks you know of for the process, ie best way to turn the engine/transmission when installing the TC bolts. I have the shop manual and have printed a couple threads for the procedure. Also are there...
  4. W

    pulling to the right only in 4wd

    Hey guys. I took my wife to the airport the other day in bad conditions using 4wd (40 miles each way). On the way I started hearing noise and feeling more vibrations from the front end. The truck started pulling to the right on the way home. Noise and pulling would eventually go away after...
  5. W

    Need Advice unitized hub threads damaged

    I'm working on ball joint project and have been well equipped with tools thanks you guys in this forum. Everything has come apart nicely with the exception of the passenger side hub. I did get it apart. Whoever put it together last time should be strung up. 2 of the bolts were driven in...
  6. W

    The Ball Joint game ...tool help

    Hey guys I have been doing my homework on changing the ball joints out (and axle u-joints)on my truck. I have seen in a post that someone used an OTC-6290 puller for the hubs/bearings however in the description from OTC it says "Services: Most 1/2-, 3/4-, & 1-ton GM 1988-2000 trucks and...
  7. W

    Auxilary wiring - key hot

    Ok, so I've taken the advice of purchasing a Painless auxilary fuse block (70103). The directions say to find a key hot fuse in the oe fuse block to control the relay. No problem there but how does one route a wire inside the cover without putting a notch in it, which I don't want to do. Or is...
Back
Top