Search Results for Query: *

Just got new tires on my truck last week and the front end just dint feel right. I crawled under to find my (4) hub bearing bolts loose on both sides. very loose on the right. I could of swore I properly torqued them last fall when I replaced u-joints. I did anti seeze them as well around the...

Just bought some new BFG AT at sears 265 75 "E" tires. Last couple of days I found the truck to be a bit squirrly so I checked the tire pressures. I found them to be at 50 in front and 80 in the rear. After i read some other posts i changed them to 60 front and 50 in the rear. I drive alot...

My 99 Transmission does not like to shift out of 1st gear on light throttle. This happens usually after a 3/4 to full throttle start. I can usually feel something pop back in the pedal like something is hanging up then shifts fine. Could this be the APPS??? Does it have a spring inside hanging...

Got a check engine light with a code of PO237. Checked connections on sensors and narrowed it down to when I dissconnect my quadzilla max mileage w/zxt I dont get the check engine light. as soon as I replug the harness connectors check engine light again. could it be the quadzilla box??? I see...

I think I am convinced to go back to 285 or 265 tires. With my 3. 54 gears I am lugging the motor trying to run 55 mph in od 1350 rpm especially while towing with my 315 tires. Running out of od at 55 I am at 1900rpm. I usually pull loads under 5000 lbs but it pulled better with the smaller...

Just wanted to let you guys what I found. One of My intake heater grid relays was fried and my truck was running rough and smoking on cold start. I looked back on a few threads and found someone used Ford starter solenoids to replace them. Well so far it is working for me, went down to my local...

I was under the truck last night doing the oil change and lube thing and found some slop in the axle u-joints. I plan to replace them myself along with new axle seals, I think the ball joits are fine. I checked some of the earlier threads on this and everyone removes the axle nut and the 4 bolts...

I took my molded running boards off that run front to back off to see what I got. Found a lot of little rust bubbles around the bolts that hold them on and a 2-3" rust hole at the rear of the left front fender on bottom. The hole was there because the drain was plugged and filled with...

I know this is my first post however I bought a 99 QC Long box and came with "C" rated tires. The door jam calls for "E" rated tires. I have only had the truck 3 days and I think I am going to the dealer monday to see if they will absorb the cost of new tires. I dont think this is safe and...