Search Results for Query: *

Hi Have a Hummer H1 with a Ppump 12v. I'll list off the issues it has and the ideal changes i'd like to get to. any help would be appreciated. Problems to overcome: 1. hard cold starts: currently there isnt a heater grid (if anyone has a grid, wiring and solenoids, let me know, i'm...

I’ll give as much detail as I can, any help would be greatly appreciated: 3 days ago I was on my way to get a new tool box for my home shop. I stopped at the first fuel station 2 miles from my home and filled up at the diesel bay, where there is no chance I put in the wrong fuel. I started up...

The steering joint at the passenger end of my steering bar failed last night. The tire/alignment shop says that my ball joints are bad too. They are quoting me a worst case scinario of $2600. Saying that they might have to replace the hub bearings as well, as they need to be removed to...

I currently have a pulling dual disk (no springs) installed. I have to take the transmission out soon to replace 4th gear (It failed after 2000 miles, the toothed portion for the shift coupler sheered off the gear under medium load!) so i'm considering changing clutches. Here are my factors...

Last night, I was driving home with no load and was accelerating after a corner in 4th gear under a medium/average acceleration and without warning, there was a loud bang, like a firecracker went off under the floor boards. 4th was instantly gone. All other gears were fine but when I put it in...

My starter circuit fuse in the engine fuse bay started to blow ever few months last fall. I'd been replacing it with 25 amp fuses. This last week it blew so I replaced it. As soon as I turned the key to start, it blew again. I tried one more time with the same result. I hotwired the...

Last week I installed my AirDog FP150. Afterwards I had to drive home, about 15 miles. Half way home I felt a change in power. It was instant, but is now constantly that way. It drives totally normal, just a lot less power. It wont smoke at all either (It normally should roll coal). I've...

With the mods I have, and 50lbs of boost, how much RW HP do you think i'm producing (nv5600 trans) when the edge is on stage 5 which states 120hp and 350 torque?

I just bought the FP150 and a Vulcan fuel line to go from the stock fuel heater/filter to the VP. My plan is to plum the FP150 into the fuel heater (no filter) and use the Vulcan kit to get from there to the VP. I've read some peoples comments that if you get the FP150, over the FP100, you...

I recently had my dual disk 13" clutch rebuilt. The flywheel was resurfaced and pads replaced and floating plate replaced (old one was cracked). A new pilot bearing and throw out bearing were installed. The pilot bearing was the stock needle bearing and the previous one was gone when I took out...

I am curious about putting semi wheels on my 00' dually nv5600. Where is the best place for adapter plates? and also rims/tires? I would love to find a used kit, is that even an option? I'm not very educated on this topic yet, so dont hold back basics. Thanks, Derek

I'm looking for a good (no chips) 5th and 6th gear from the counter shaft. (two closest to bell housing). I would need them by friday, so if you got some that you could ship by end of Tuesday let me know. Derek 952 807 8102