Search Results for Query: *

I have intermittent resistance in my clutch pedal. 7 years ago I installed a new valair clutch and an HD master slave. About a year to a year and a half ago I had the G56 rebuilt and a new southbend installed. Recently I've been getting some intermittent resistance in the pedal and not sure...

Has anybody had issues replacing bearing on a lippert trailer axle? I have (2) 6000 lbs axles under my 5th wheel And have a wheel bearing going out. The use nevrlub bearing/hub combo. I've searched for just bearings so I dont have to buy the whole hub which retails for 350.00 and can not find...

When I originally installed my airdog the only place I could find to mount on a short bed was right below the drivers door on the frame rail. It hangs down below the frame and rocker pannels. This would not be a problem for a highway only truck but since I've installed a carli lift and go off...

I need information on t-case skid plates. oem vs. hd after market, and is there an after market manufacturer for the skid plates? I do not currently have a skid plate so, if there isn't an after market, then oem would be fine. But where is the best place to find one for a reasonable price?

Does anyone have knowledge of any bumper companys that sell prefab bumpers that ship pre cut just needing to be welded?

Just purchased the Edge insight cts and starter kit w/ Pyro to replace mechanical gauges and to add a couple other parameters to monitor. After installing it and playing with it for a couple, I need to know more. As for as rail fuel pressure. : what is the normal pressure at idle? : what...

I'm ready to purchase a carli suspension lift and can't decide which system to get. So I spend all of my time on pavement but do travel gravel roads from time to time. My budget is around 2000. Does any body have any experience with the commuter 2.0 or the starter kit? With the commuter, is...

Has anyone installed the carli starter kit on their truck? Thinking about ordering, and want to get some feedback from people who are running it.

So I've noticed my truck wandering while driving down the road. There is no noticeable play in the steering and I have a new tie rod and ends and ball joints are good. So I need to diagnose this problem, it's kinda like the wind pushing you around. I need new bilstien shocks so I'm wondering if...

I just installed the airdog fp150, and i thought i read somewhere that you need to remove the fuse from the pump before plugging in and downloading smarty. I cant seem to find that info, does anybody have that information.

I have a quick question about removing the oil pan to change out the gasket, maybe someone can help. Just looking at the pan, it doesn't look like it will drop out once unbolted. So my question is will it dop a little, enough to clear the bell housing, and slide right out? Any comments? thanks.

i installed a new fuel control actuator from cummins, that didnt do the trick so i installed a new fleetguard fuel filter and like the FCA still running rough. i have noticed a little white smoke when i start it cold. the motor sputters a little when i accelerate when cold. i took it to...

i drive a early 07 and i recently pulled my 7000 lbs rv from phoenix to amarillo. i ran my smarty on level 3 and drove 70 to 75 mph and taking it easy up hills watching my egts. well since i have been here in tx i have only started it a couple days a week and the first start of the day it idles...

I installed a valair ceramic/kevlar clutch kit in my 2007 ram 2500 on october 19. So far i have about 450 miles on the clutch and i have followed the break in directions. My question is when i am at a stop and i start releasing the clutch, if i dont time the throttle right with the clutch, the...