Search Results for Query: *

Its time to replace my clutch and I am looking for some input. I am not sure if the clutch I have matches my signature or not. I bought the truck from a former member who I am not in contact with anymore. I copied his signature and pasted it to mine. I do know that he replaced the clutch right...

I got in the truck yesterday and it started but cranked very slow. I pulled both batteries and had them tested. Both failed so I replaced them. Still had same problem so I pulled starter and had it tested. It also failed so I replaced that too. After I replaced the starter there was a click then...

6 yr old clutch with probably about 60 or 70k miles on it. I drive the truck to work and back every day. Clutch has been perfect since the day it was installed. I hopped in the truck to go to work yesterday and immediately noticed that it took less force to press down the pedal. Normally when I...

Bad front end wobble at 35-45mph. If I turn the steering wheel slightly it goes away. Drag link was a little loose so I replaced it and no difference. Wobble goes away almost completely at higher speeds. Nothing seems loose when I raise the wheels off the ground. U joints are good. Tie rod ends...

I put the truck on jackstands and front driveshaft spins when in 4wd. Applied vaccum to shift motor and it works fine. Could not find any bad spots in vaccum line and have good vaccum at transfer case vaccum switch, but little at shift motor. Pulled switch off of transfer case, plunger seems to...

70 miles from home and carrier bearing on rear driveshaft popped out and is pretty tore up. Wondering if there is any problem with pulling rear drive shaft and driving home in 4x4? Also need help on replacing carrier bearing assembly?

I've had edelbrock shocks for a long time. They have been awesome but one of my rears failed recently. Cannot find a part number for edelbrock that will work for a 2 inch lift, only a 3 inch. Has anyone tried the Bilsteins from Genos? If so, how do they compare? TIA for any input.

Rough weekend! Changed filler neck, no problem. Changed fuel filter, sucked but ok. After changing fuel filter, priming fuel system, and starting engine, reved @ about 2500 for 30 seconds and then felt steering wheel jerk to the left. Brake and steering assist was gone. $400 later I have...

This is a power steering nightmare. It started out in a parking lot when I locked the steering wheel to the right. System started growling immediatley and steering was at about 50%. I nursed it home and replaced the ps pump. With the new pump I had no steering and no brakes so I put the old pump...

I changed the seal on my passenger side outer axle this weekend and when I went to put the intermediate axle back in I noticed a bearing that was just trashed. You can see it by looking in through the cad housing. It's in between the diff and the cad right at the cad housing. It's pretty tore up...

Thank you for the input from my previous thread. I need to get the truck back on the road asap. I bought a reman pump, put it on and had no brakes and no steering when I was done. I put the old pump back on and the truck was the same as before, good brakes and had power assist on the steering...

I'm trying to buy a power steering pump and the auto parts store has two options. One has an internal filter and the other doesn't. The one with the filter is a little cheaper which doesn't make sense to me. Does anyone know if it matters one way or the other? I have a 1997 ram 2500 12v ctd...

Looking for help with changing front right axle seal on 97 2500. Cant find tools to pull or set seal. I pulled axle out and tube is full of sludge. Need a good way to clean the tube. Any help would be greatly appreciated.