Search Results for Query: *

  • Users: kwoodson
  • Content: Threads
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. K

    AirDog quality and customer service issues

    I purchased an AirDog FP 150 in the summer of 2012 and installed on my 2003 2500. I worked fine for six months and then died, I called AirDog and another motor assembly was shipped out. It lasted approximately 6 months, and again died, called and another was shipped out. 6,7 months later same...
  2. K

    Engine/Transmission (1998.5 - 2002) 1998 24 Valve no torque convertor lockup

    I have just bought a 1998 24 valve, and the torque convertor will not lock up. I installed a "mystery switch" in order to try and lock it manually, and.. it still will not lock up. Any suggestions
  3. K

    Engine/Transmission (1994 - 1998) Replace V10 with 5.9

    I have a 1997 2500 with a V10, the question I have is, has anyone replaced the V 10 with a 5.9? And if so how much trouble is the conversion? I have a 1997 with a cummins for the downer vehicle.
  4. K

    2003 guage issues

    I have a 2003 and I am having issues with the dash cluster. While driving the chime will chime and the gauges will fall to zero momentarily, sometimes it will be only the fuel gauge, and at other times it will be all gauges. Any thoughts.
  5. K

    Adjusting Turbo Boost

    I have an 03 that i would like to raise the boost pressure on, problem is, don't know how. Can someone help me with this?
  6. K

    Engine/Transmission (1994 - 1998) Transmission circulation question

    Just installed a trans. temp gauge on my 97 Dodge because when pulling on long steep grades, engine would heat considerably. I have discovered that the heat was from trans. I have also discovered that the trans. will heat up and hold a high temp. even after I back out of throttle, but as soon as...
  7. K

    Engine/Transmission (1994 - 1998) 47RE to 48RE tailshaft

    I'm thinking of installing a 48re in a 97 2500 4x4, question is, will the tail shaft from my 47 fit the 48? the 48 I'm looking at is from a 2 wheel drive.
  8. K

    2nd Gen Non-Engine/Transmission AC Help

    I have a 1997 and the AC compressor clutch will not engage. You can run a 12volt jumper wire to the clutch and it will engage and the ac works fine. I have checked the freon and it is fine, jumped the high pressure and low pressure switches and that doesn't work. My question is where is the...
  9. K

    Need part number for cap

    I'm trying to find the cummins part number for the cap that is used to cap fuel line fitting on a 2003 common rail.
  10. K

    Common rail cap

    I'm trying to find the the cummins part number for the cap that is used to cap fuel line fitting on a 2003 common rail.
Back
Top