Search Results for Query: *

I have a 2008 4500 CC. Replacing driver caliper, when I try and screw in new brake fluid line bolt into the new caliper it will turn 2-3 threads then stops. Both new bolt and old bolt screw in old caliper just fine. I also ran a tap thru new caliper and tap went in with no problems using only...

Is this the Map Sensor on a 08 6.7?

My ETC light came on. Ran Smarty and P0049 - Turbo Turbine Over speed and P0088 - Fuel Rail Press High code were shown. Any experience on what would cause these codes?

Hooked up Smarty Jr to change settings. After update and turning truck on 3 codes came on: P0487 EGR P0601 Internal Memory Invalid P2141 egr Airflow Throttle Control Circuit Low (Smarty Jr said was unknown) I have the delete kit and Plunger is out and unplugged. Tried twice but cannot clear...

Where is the Barometric Pressure Sensor located on 2008 6. 7?

After installing the delete kit on 2008 6. 7, Can I just unplug the sensors instead of tie wrapping them up against frame? Just tired of the Barometric Pressure sensor throwing the DTC.

After installing the dpf delete kit about a year ago. I wrapped and tied all sensors off to the frame. Lately I noticed when I'm hauling and going over a bridge in cruise, when it downshifts to get over hill the Barometric Press Sensor code comes up and I have to pull over and reset it...

Anyone know of a link that shows step by step procedure in replacing the rear diff seal in a 2008 4500?:confused:

Looking to order rear brake pads for 08 4500. Any sugestions??

Looking for info on this code

Does anyone have pics on where the ccv fitler is located??:confused:

:confused:P2229 Code. Barometric Pressure High. Never heard of this code before, any insight on this?

Just installed a DPF delete kit with smarty jr. 1st trip got 10 miles down road and check gauges light comes on. I hooked smarty to truck and it reads a PO63D code which says "Generator Voltage Sense High". Is this code related to the deleting the DPF?? :confused:

Computer says exhaust filter is full and its been a few days and doesnt look like its going to clear its self up. Truck is out of warranty and no annual emssion check where I am. Pros and Cons of removing filter?... ... . and where is it located and how I know its the right one Im removing.

Ok, I have a 08 4500. Bought in Jan 09. It has always idled rough to the point where I thought it would die out at times. I had dealer check it 3-4 times over the yrs and they never find anything wrong. I have tried different fuel stops, attives, etc etc... ... ... Do the 6. 7 idle THAT rough...

I have an 08 4500 with manual mirrors. Can I install a set of power mirrors?? Not sure if connections or there already for hookup.

I have an 08 4500. About 2 wks ago it starting having a whistling noise when I would turn exhaust brake on whick still does, and now a slightly lower whistling noise at idle.

I have an 08 4500 auto, has anyone used any transmission oil additive? Also, is the pan gasket re-useable?

I called dealer to find out how much oil the rear differential took on my 2008 4500. (Called dealer because manual doesnt state that info!!!) Well all in all I misunderstood him, he said 8. 8pts, I thought he said quarts. Got to 6qts and it started flowing out fill hole. Was told oil had to be...

:confused:Is it safe to use 85W-140 Lucas gear oil in the rear dff? I have a 2008 4500 and I'm not sure if I'm supposed to use synthetic oil??