Search Results for Query: *

I have been looking through the FSM, forums and general internet search's and I have not found a clear answer to what the logic behind the exhaust brake (EB) control is for the 2006 5.9 Cummins ECM. I have found (and from my experience) that is will run the EB to aid warm up (under 900 rpm, 170...

I have been looking through the FSM, forums and general internet search's and I have not found a clear answer to what the logic behind the exhaust brake (EB) control is for the 2006 5.9 Cummins ECM. I have found (and from my experience) that it will run the EB to aid warm up (under 900 rpm, 170...

I have read a lot of different threads about steering issues and between my 2gen and 3gen trucks I have replaced every part on the front suspension and steering. My current truck, a 2006 MegaCab with 254k miles, has had a complete new front end put under it. Not because of the steering issue...

I have been having a wondering issue with my steering than has progressively been getting worse. My first steps to diagnoses was to check that all suspension parts are torqued and lubricated. After that I looked for unusual signs of wear or contact. When than did not reveal anything I...

Please add Tapatalk support to the forums. It help with accessing the information, especially while mobile. A few times I have been stuck somewhere with only my phone to diagnose and repair an issue. This forum is harder to use on a mobile browser as compared to using other forums that support...

Last month I was lucky enough to win the TDR contest for Best Stupid Warning Label. https://www.turbodieselregister.com/forums/free-stuff-tdr-members/236710-best-stupid-warning-labels-winner-gets-cfm-5-9l-intake-manifold-ends-may-25-2012-a.html The air horn and tube showed up in perfect...

Well I had to drop my tank for a second time. The first time I replaced the sending unit and reinforced the basket. It had whorled out the screws that position the lower section. This time I was having a 1/4 tank rough start the gauge was not reading correctly all the time. I thought the...

Has anyone setup a bypass switch for the abs system on a 96 2500? I currently have to pull the 40a fuse to disable the ABS while I am not on pavement. I need to look at diagrams for a convenient wire to put a switch on. Or will a main system brake warning light cause the abs to not...

After a lot of researching of how to modify and tune the AFC on my P7100, I have collected the following guide: The following modifications to the AFC may not be either emissions control approved or safe for the motor if done incorrectly! Adjust with caution and precision as anything falling...

I am looking into swapping my Dana 80 (open diff and drum brakes) for a Dana 70 (Posi and disk brakes) from a 2001. I know that it will bolt in, that the gear ratio's are the same and that it may be about 2" wider. My question is this: Will the reduction in axle load capacity be large...

I put this clutch in a few weeks ago and now have about 1500 miles on it. I want to first say that I seen the write ups in TDR and when it came down to selecting between Southbend and Valair, the final deciding point was the noise reduction and chatter. I have a good freind, who is also a...

So I want a high idle for my truck now that we are going into winter. My friend has a 06 and can use his cruise control to raise his idle for warm-up and go me thinking. After looking at the wiring diagrams and operation of the vacuum controller I have come up with an idea of how to do it...