Search Results for Query: *

What is the best way to flush/backflush my engine and cooling system to remove all antifreeze and clean system? Switching from pink peak fleet charge to regular green prestone, not the low silicate. I used the fleet guard restore and ran truck with heater on high for about an hour on high idle...

Having an issue with the fuel cutting out when accelerating. Truck is a 5 speed and it only does it when pulling out from a stop while accelerating to shift to third or if I slow down, have to downshift and I get back into the pedal. Doesn’t do it after leaving off for every shift and getting...

Looking for a reputable transmission shop in Pa that’s good with rebuilding Chrysler transmissions (namely the 727 torqflite). The one in my truck doesn’t hold in park and is having a hard time up shifting so was told it’s probably due to the pawl being broken off which then affects the line...

I installed an electronic Isspro 30lb. fuel pressure gauge on my 01. The sender is installed at the airdog. When I installed the gauge I did not use a snubber (wasn't thinking). The gauge worked for a while reading around 12-15lbs of pressure but eventually read 30 lbs and still does today...

My low oil psi light is coming on after the oil gets up to operating temp. I have good oil psi on start up (50-60lbs) and while driving (50lbs) but once I come to a stop it drops around 23-24psi and trips the light on the dash. The truck had a mechanical gauge when I bought so I just left it as...

Hi all. The trans in my truck doesn't seem to want to shift into second gear unless you lift off the throttle and get back into it. I serviced it back in 2016 at 150k miles with Mopar ATF and it now has 171k. I also have an issue where the truck won't hold in park and the shifter sometimes...

My trans isn’t engaging in park. It will begin to roll as if it were in neutral. Shifts into all other gears without any trouble. However a couple months ago I couldn’t shift it out of first or second up into drive. Haven’t had that issue since, just won’t hold the truck when put in park. Not...

Hi, I need to replace my driver side floor pan in my truck as it rotted to nothing (don't they all lol). Wondering what aftermarket brand is best as far as fit, price, originality and strength/thickness. Thanks in advance!

I have an 89 D250 with torqflite 727 auto. I’m unable to move the shift lever into reverse or park. However I am able to shift into drive, 2nd and 1st. Is it an adjustment issue or internal?

I have a bad brake master cylinder on my '01 2500 and would like to replace with a new OEM unit. I called several dealers with no luck on a new one, (told me their no longer being manufactured). Wondering if anyone has one stored away they'd be willing to part with. Just need the cylinder. Thanks

having a hard time removing my rear brake rotors on my 01 with Dana 80 rear (SRW). All clips are off the studs and park brake seems to be backed all the way off. Hitting it and pulling pretty hard but no luck. Tried a little heat as well. Anyone else run into this problem?

Having an electrical problem with my truck. When driving the voltage gauge drops to around 10v and dances while driving and when turn signal is on. Headlights also dim due to the low voltage as well as the speedometer being off around 5mph. Had a test done on the charging system which resulted...

Hi all, I've replaced both front calipers on my '01 2500. After bleeding, the pedal is firm. Once truck is started the pedal goes to the floor. Went and bled all 4 calipers after thinking air was my problem. Didn't help any. Where else can there be air trapped or, do I have another problem?

Looking for a rust free fuel tank strap bracket for a truck with an 8” frame. It’s the rear one that the tank strap hooks into and goes up and is rivited onto the crossmember. Please let me know if you have one or know of one. Thanks!

Looking for a rust free fuel tank strap bracket for a truck with an 8” frame. It’s the rear one that the tank strap hooks into and goes up and is rivited onto the crossmember. Please let me know if you have one or know of one. Thanks!

Replacing the brake lines that run along the left frame rail. Where is everyone buying their lines? Thanks

I'm going to be painting the chassis on my 89 D250 in the near future and will be using KBS coatings product. The kit came with a couple cheap bristle brushes and was wondering if their any good to use. I intend to brush the product on not spray and don't want brush streaks. Anybody use this...

Hi, wondering what coolant I should use in my 01 24v truck. I hear there is coolant meant for use in gas engines and some meant for diesels. Any help is appreciated, thanks!

I'm having an issue with the lights flickering on my 91 W250. The headlights, taillights, dash & radio lights flicker when driving and idling. Any ideas as to what the culprit could be?

Hi, looking for pics of how the high idle brackets mounts to the accelerator pedal. Truck is an 89 D250 auto. Thanks.