Search Results for Query: *

22 2500 mega cab. While driving down the highway I have to hold the steering wheel to the left. If I make the wheel strait the truck pulls to the right. Figure it needed an alignment. Took to Les Schwab who brought me back and showed me the truck. Front alignment was in spec. Said however my...

I went on a 2k mile road trip with my 11k pound 5th wheel and towed over I-70 through Colorado and Utah. Had quite a few steep long pull. I monitor the engine, trans, oil temp while towing. The engine stayed cool. Max I saw on that was around 213 for short periods. My question is the oil temp...

Diamondback HD SXS truck bed cover. Fits 2010-2024 Ram 2500/3500 short bed (6’4”). Can hold 1600lbs of cargo. Comes with 12ft folding aluminum loading ramps, extended wheel ramps, and tailgate brace so the bed can be accessed with a sxs loaded. Can hold a 60” wide SXS or atv and a max length of...

I have a Banks Automind programmer. The model is 66412. It works for many models and years. It has 4 different programs all for an emissions intact vehicle. I used the work/tow tune and noticed better power, shifting and mileage. It works as a code reader as well. I bought a new truck and it’s...

I have searched the forum and seen some posts related but not completely. I recently purchased a 2022 2500 limited with 7k miles. When I went to the dealer to pick it up battery was dead and wouldn’t start. I was going on vacation so told them to keep it for the week and look at it. They ended...

I have a 2010 6.7 with 68rfe trans. Bone stock as far as engine goes. With the way things are going EPA wise I don’t think I want to delete it. I’ve been google searching various options and have found a lot. I’ve looked at the Stealth Module, Banks/super chips hand held tuner, and the more...

I had my check engine light come on this morning. I ran the codes and got the following codes… P241a- mis matched reading between the upstream and downstream o2 sensors. p22b5 - is a open circuit in the pump current. Has anyone experienced these and how do you correct it? 2010 6.7

2010 6.7 Cummins 96,xxx miles. I just rolled past 96,000 miles and got the “perform service” displayed in the dash. I had no check engine light, or any codes. Is this the ccv filter again? I just changed it at 67,500. Is there any other way to tell what it is or should I change the ccv filter...

I recently sucked out and replaced my power steering fluid. I did the turkey baster method and replaced with mopar atf+4. I have noticed now after I turn the wheel and the wheel spins back to center it shudders. It doesn’t return smoothly. The fluid level is correct. What could my problem be?

Thefts in my area are up and I want to install a kill switch. Has anyone done so, and if so, how? I have a 2010 with 68 auto. I have looked for a kit but have been unsuccessful and online info seems to be sparse. Thanks