Here I am

Search Results for Query: *

  • Users: CSloat
  • Content: Threads
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. C

    Engine/Transmission (1994 - 1998) Starting trouble, have to pump throttle

    A while ago I noticed that after I had been driving the truck for a couple of hours it wouldn't restart unless I pumped the throttle while cranking. I posted the question here and someone suggested I remove this little boot (forgot what it's proper name is) on the side of the fuel pump. I did...
  2. C

    2nd Gen Non-Engine/Transmission Is DT Products still in business?

    I couldn't find their website or phone number. Thanks for any info, Craig
  3. C

    Engine/Transmission (1994 - 1998) Starter cranks, truck starts, then stops

    After I've been driving for over an hour and stop the truck it has trouble starting again. When I crank the starter it fires, then stops Immediately. I've noticed that if I pump the throttle while cranking it will start. The truck has 165k on it... does this mean its time to rebuild the...
  4. C

    Engine/Transmission (1994 - 1998) Transmission leaking or Tcase leaking

    I have a 97 4x4 with the auto trans. I noticed a large puddle of pink fluid on the ground, looked underneath, but can't tell whether its coming from the trans or the t-case. I took it to a local 4x4 shop and they told me it was the rear seal on the trans and that they didn't work on...
  5. C

    Engine/Transmission (1994 - 1998) Any shops that can timing in So Cal?

    My local injection shop has a good reputation, but when I asked them about advancing the timing to 15. 5* they said this was not possible and they would have to guess. I brought them the info from piers site, but they still won't do it. Does anyone know of a shop in Southern California that...
  6. C

    2nd Gen Non-Engine/Transmission Aluminum Track Bar?

    I just installed a DT products trackbar. The mounting bracket is a good design and very strong. The rod ends are steel, but the bar is made of aluminum. Do any of you think there is a strength issue here or is it ok for this application? A little history: My stock trackbar is shot, so I...
Back
Top