Search Results for Query: *

I have been shoping around for new replacement fenders and could use some advice on where to buy them. I saw some on ebay, but don't know if they are reliable/good quality peices. Any help would be appreciated. Steve

I don't know when the last time such a post was made or if there is a Zagat for the web... but, this has to be one of the very best forums on the internet, period. I don't think there is enough room on this page for me to thank those who made this possible or to thank the members for their...

I bought a used dana 80 for a dually, supposedly with 180,000 miles on it. When I brought it home, I discovered I couldn't turn the axles. When I took off the rear cover, the caps were on wrong and the carrier bolts were rubbing against the left cap (the cap bosses were facing toward the...

Hi I bought a used Dana 80 for a dually but noticed when I got home that the pinion would only turn a half turn. I took off the rear cover and noticed that the bolts on the right side of the limited slip housing were rubbing on the bossess on the right cap. Each of the two caps have 2...

Hi I need to know the width of a dana 80 for a dually pick-up and the width for the cab and chassis. I did a search and couldn't find it anywhere. Any help would be greatly appeciated. Steve

Okay, here are the part that I have to do the dually conversion on my 1997 SWD 2500: 1. New front '96 dually rotors and used '99 3500 dually calipers. 2. Nice '01 dually bed. 3. '96 Dana 80 dually rear end I have a few questions: 1. Should there be any surprises with the...

I got a leak on both sides of the cab of my '97 Ram Extended Cab and can find them (water accumulates on the outside floor near the door). The inner door mouldings and extended cab window mouldings look fine. No rips, tears, etc. But I can't seem to locate how the water is getting in? I even...

Can someone please direct me to a place that has compressor and clutch rebuild kits for a '97 Ram Diesel. Even better, can someone tell me how difficult it is to actually rebuild one, clutches and all. I assume that the cylinder would need to be honed, with new gaskets, seals and oil installed...

Hi Folks I replaced the fuel level sending unit in my Ram, but discoved that the plastic inner housing that goes in the tank was loose from the metal outside housing that it attaches to (the plastic housing, which holds the sending unit, was sliding in the metal outer housing). I could'nt...

I have a '97 Ram that I tow 11,000 lb with. I was towing a little while ago and had to stop quickly. After I came to a stop and my brakes stopped smoking, the ABS (rear only) and Brake light came on and will not go off. I disconnected the batteries to reset the computer, but that did nothing. I...

I had a ticking noise coming from around the power steering pump in my '97 Ram (110,000 miles). The fluid level seemed a little low, so I added some but it kept ticking. I drove it for about 1000 miles and the ticking has gone away. When I'm in drive with the brake on, I can feel a slight...