Here I am

Search Results for Query: *

  • Users: Cariboo
  • Content: Threads
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. C

    2nd Gen Non-Engine/Transmission Wiring for driving lights

    I have some driving lights that I want to wire into the high-beam switch. The lights came with a relay. I understand my 99 2500 high-low beam switch controls the negative side of the light circuit. If I attach the relay input hot lead through a fuse to the battery (the one that ordinarily would...
  2. C

    A/C condensor

    I have learned the hard way that if you put a screen in front of your radiator/condensor to eliminate bug buildup, be good and sure that there isn't any chafing on your condensor input or output lines. $600 and a new condensor later, I'm a little bit wiser. :{
  3. C

    boost gauge problem

    I just installed an Isspro 2-50 mechanical boost gauge, plumbed with a piece of 1/4" rubber hose to the manifold test port. When the engine is under load, pulling about 16-17 psi, the gauge makes this sort of buzzing noise and the needle flutters a little. Is this a bad gauge, or does the...
  4. C

    Winch & front springs

    I'm thinking of building a mount for a Warn 8274 to fit into my fromt receiver hitch, and have heard that the extra weight may cause bouncing of the front end, misaligned headlights, etc. I'd guess the setup will weigh 100 or so pounds. Has anybody experienced problems like that? I don't...
  5. C

    Fuel pressure gauge plumbing

    I know I'm supposed to use braided stainless line for my mechanical fuel pressure gauge, but I'm wondering if plain old rubber fuel line is acceptable. It would be run through a new grommet in it's own hole in the firewall to prevent chafing. If the consensus is that I'd be wise to use...
  6. C

    A-pillar paint

    I got myself an Autometer A-pillar with guage pods, and want to paint it to match my existing pillar (dark grey). Where can I get a small can of spray paint to do that? Does DC carry something like that? I don't really want to have it custom-mixed, because I don't need much. Thanks.
Back
Top