Search Results for Query: *

I'm having an intermittent electrical problem with my 2003 3500 with 275,000 miles on it. I'm the original owner. I've been chasing this problem for a while and I need help from someone smarter than me to find the source of the problem and fix it. It started months ago with temporary and...

I'm in need of the Northwest KDP jig. Just picked up a '95 and it hasn't been fixed. I tried to PM illflem but he's not receiving PMs and at last check he was the keeper of the NW jig. Any suggestions? If there is another area with one available, I'll gladly get the work done quick and ship it...

I keep noticing a puddle on the floor in the garage just inside the right front tire. If I were running the AC I'd expect it to be condensation from the AC unit. However, I have not been running the AC. Anyone else noticing the same thing? It's water. I've noticed it off and on since I...

Does anyone know a source for a switch with a built-in timer or a seperate timer circuit? I've added some accessory lights and I want to have them automatically shut-off after ~10 minutes. Otherwise, I'm going to come out of the woods one day and find a truck with a dead battery :( . I...

I've been searching the forums for Air Filter improvements. I'm looking for a picture of Scotty's III Ram Air system (installed). I couldn't find one of it installed on the '03 Ram. Can anyone help? Thanks,

I see lots of spare fuse spaces in the factory fuse box. I'd like to use a couple for some added accessories. Does anyone know how to access the back of these in order to activate those fuses like they were factory wired? TIA, Bill

Guys, I need some help with the trailer wiring. I have done some searches and haven't seen a post with the answers I need. My '03 didn't come with the trailer package (that's another story... ). I'm trying to remedy this. Here is what I have: 1) There is a flat four trailer connector...

I sure could use some good advice. I was wrenching around on the truck again and oops... My hand smacked into the Rear Wheel Anti Lock (RWAL) Combination Valve that is mounted below the brake master cylinder. There is a wire harness plugged into the combination valve that goes to the...

Since I can't search, I'll post instead. Took truck in to get aligned and learned the Thrust Angle was out. Thrust angle? That was a new term to me but it means the rear axle is not parallel with the wrong one. In my case, it's aims to the right a bit. If you've seen trucks doing the crab...

Somewhere I saw a rubber canopy seal for sale. I can't remember where. Does anyone know where I can get a heavy duty reusable seal? The foam tape doesn't hold up in the summer heat and I take the canopy off 6-8 times a year. I'm looking for something rubber that I can mount to the canopy...

I had an interesting experience last week. I was in the mountains doing some late season bird hunting. The roads in eastern Oregon were a mess. They had some snow on them and it had been cold but on this day it was warm and everything was soft and muddy. The bolt that connects the track bar...

I installed a Luke's Link a couple of months ago to tighten up the track bar. Worked like a charm and was pleased to get my steering back in control. Spent the last two weeks hunting and driving some bad dirt roads and a few no-roads. On the way home she was loose again and hard to keep on...

Has anyone used the replacement oil plug from Geno's "EZ Drain Plug?" I have a few questions: 1) Does it allow all the oil to drain out? 2) Does it seal in a fail safe way? It sure would be nice to eliminate some of the mess. Thanks, Bill

Gang, I've read a lot of threads about how to increase power and torque. I'm ready to start bombing the truck but have one concern; I don't like smoke. For me, if she smokes, she sucks. Can I still get the improvements from a new plate, new injectors, new exhaust, etc. , without getting...

do I have to do some sort of flush of the potrolium oil??? Bill L.

I love this sight:D :D :D I got to use the KDP jig today. Had to work alone and was realy unsure of taking on this task. Thanks to the great support of this site and the people who willingly contribute their time and knowledge, the job was a success!!:cool: Took me 3 hours and I was...

Installed Luke's link on the end of my track bar tonight to tighten up that sloppy old frond end. It seems to have tightened up the steering okay but I still have a Klunk noise when I come to a stop. :mad: It seems like I can feel it under my feet as much as I can hear it. Anyone else had this...

There is a hissing noise coming from my heater/ac switch when I shut the truck off. It may be there when it's running too but it's difficult to tell with the engine noise. Does this mean the switch is going bad? Is this a vacuum switch? Is there an easy way to get to it? Will it cost...

When I'm pulling my boat on a hill (light load of 3500 lbs), I sometimes hear an electic fan kick on and run for a couple minutes. I don't see any change in my engine water temp. The fan sounds like it turns some serouse rpms. What is it? What set points trip it? Thanks for the hints. :D

Thought some of you may be interested in this product as well. http://www.truckvault.com/ I was at their factory checking them out after someone recommended it to me. They look pretty good. I want to be able to pull something out to reach things but like the idea of drawers so that I...