Here I am

Search Results for Query: *

  • Users: rKortan
  • Content: Threads
  • Order by date
Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. R

    2nd Gen Non-Engine/Transmission could my rear axle be gone?

    I have been listening to a sound that I was told is coming from my tires. So I had been waiting until they were worn out until I replaced them. This week the sound turned into a banging that gets louder when I accelerate and goes away when I coast. I got under my truck with the transmission in...
  2. R

    Engine/Transmission (1994 - 1998) Help with TSB 09-07-96

    I found this TSB which describes my oil leak. I went to Carson Dodge and ordered the bushing # 4874879 listed on their computer. But I don't think it comes with any type of installation tool. Has anyone performed this TSB and if so what are the procedures for getting the new bushing installed...
  3. R

    Engine/Transmission (1994 - 1998) Throttle Position Sender Replacement

    After reading up on the forum about why my transmission will come out of lock-up often, I now think I need to replace my TPS. I have gotten to the point where squirting contact cleaner on the shaft works for shorter and shorter periods of time. ( I have separated the wires and changed the temp...
  4. R

    Engine/Transmission (1994 - 1998) faint beginning of grinding sound

    I have noticed a slight change in the sound of my drivetrain lately. It seems that at about 35-40 mph I have a slight grinding/rubbing type of sound that feels like it's coming from under my feet. I have a 94 auto/4wd. My trans (BD)is two years old with about 32k on it. My transfer case has a...
  5. R

    Engine/Transmission (1994 - 1998) what is the rubber cover against the engine on the driver side

    While searching for an oil leak around the power steering/vaccum pump area I noticed what appeared to be a rubber cover that is built as though it is supposed to fit tight against the engine. It is warped at both the top and bottom causing it to be pulled away from the engine by about 1/2 an...
  6. R

    Towing from Gardnerville NV to Tampa area

    I am leaving this Sunday going to Tampa for a few months and was wondering if anyone knows why the computer models all say I should take I-80 east and turn south in Nebraska. I was planning on going south from home through Vegas to I-10 all the way to Florida. Is I-10 in such bad shape it isn't...
  7. R

    Engine/Transmission (1994 - 1998) Truck won't start

    I just left a fuel stop and experienced a noise (pop), then an electrical smell. I pulled into a car wash to look under the hood and could smell a burnt electrical odor and hear a loud screeching sound. I shut the truck down to take a look and couldn't really see anything that looked wrong. I...
  8. R

    Engine/Transmission (1994 - 1998) Just ordered 3k govenor springs

    Well I finally got tired of hearing everyone talk about the way their trucks ran with the 3k springs. I am so envious of the power of the new trucks but I can't bring myself to part with the cash so I will continue to BOMB my 94. I currently have a TST plate ( 230/605), 215 injectors , Banks...
  9. R

    2nd Gen Non-Engine/Transmission Trouble with Borgeson Shaft installation

    I started to install the new steering shaft from Borgeson and came to a quick halt when I couldn't get the old shaft to compress for removal. I put some WD-40 on the slip joint and plan on giving it another try later. Does anyone have any suggestions. If I can't get it off the second try it...
  10. R

    Engine/Transmission (1998.5 - 2002) Pac Brake won't turn off

    Last night I turned on my exhaust brake coming down a grade and it would not release at the bottom of the hill. I checked the vacuum, I pushed the button on the switch under the hood, I turned the cab switch on and off, no effect. The only way I got it to release was turn the motor off and...
  11. R

    Engine/Transmission (1994 - 1998) Changing to 4 inch exhaust

    I am changing from a stock exhaust without muffler or cat to a 4" Banks with a resonator. Currently I have the exhaust thermocouple located in the pipe 3" from the turbo. I want more accurate readings and intend to put in a new thermocouple in either the Pac Brake housing or in the manifold...
Back
Top