Search Results for Query: *

I had the Banks 6-Gun with Speed Loader on my 2005 and it gave me a lot of trouble. Most of the time, the truck ran fine, with decent power gains. Every now and then, it would start misfiring violently no matter what setting the switch was in. The CEL would come on and a code check revealed a...

I would venture to say the heat you noticed is from the stepper motor. The industrial stepper motors I use tend to put off a some heat.

The part number you posted is for a 4in muffler, from what I can tell. Any idea on a similar muffler with 5in ports? I apologize if I am being difficult.

Anyone have experience with a 5in Donaldson? If so, how about a part number?

My thought/question exactly!

Actually, the reason this happens is that the gauge needle is operated by a small step motor. These motors will stay in their current position when power is removed, assuming there is not a load on the motor greater than the holding power of the internal magnets. On another note, I installed...

It does shift better with more pedal, but I can't always do that. Some people around here drive too slow. Are there any software or hardware fixes for this problem?

Hi everyone! I am new to TDR and relatively new to Dodge ownership. I recently traded my 2000 Ford F-250 7. 3 in for the 2005 Dodge. So far, I am quite please with the truck. One exception though: on light to moderate acceleration, the transmission seems to hunt around for a gear. It did this...