Search Results for Query: *

I have been using the 5K potentiometer for about one year with great success. I have it set at 2 volts and I rarely have a need to change the voltage. The best part is the converter stays locked much longer on deceleration. Remember while being fed a constant voltage within the range of 1...

I found a great book on 727 Transmission. This is the same trans that is in our trucks with out the overdrive and locking tc. Torqueflite A-727 Transmission How Rebuid Modify MANUAL The best price on this book I found on Amazon.com

This seems to be a good description of how eliminate the TPS. You need to get the following: 1)A 5K potentiometer, 1 watt rated. It should have three terminals on the back. I used a one turn pot, you can use a 10 turn if you want finer control. 2)6'-8' of 3 conductor 18 gauge shielded...

I took the truck on a 900 mile trip (down and back) into Mexico over the holidays. The truck did great all the way down, even on dirt roads. I went on a little outing, about 100 miles round trip. We started on our way back from this little trip it was fussy. The check engine and trans temp...

Tell me about the codes by doing the key on-off-on-off-on thing?

When the check engine and trans temp flash together it seems so fast that I count the flashes. The 'wait to start' light DOES WORK normally. The only time I noticed that any other dash light or gauge seemed to act strange was the speedo may have seemed a little higher than normal. This could...

I did try the 1k ohm resistor. Then I put in a different sensor. These did not seem to make any differance.

I have a 95 4x4. When this happens it has been locking up the Torque Converter and goes into D3 intermittently at any and all speeds. It does not seem to have a pattern. I drove it over 100 miles with one stop and no problem. Then drove around town doing some last minute things getting ready for...

You might try this, it worked great on my 95. I set it at about 2 volts. 95 Eliminating the TPS on Automatics You need to get the following: 1)A 5K potentiometer, 1 watt rated. It should have three terminals on the back. I used a one turn pot, you can use a 10 turn if you want finer control...

You might try this, it worked great on my 95. 95 Eliminating the TPS on Automatics You need to get the following: 1)A 5K potentiometer, 1 watt rated. It should have three terminals on the back. I used a one turn pot, you can use a 10 turn if you want finer control. 2)6'-8' of 3 conductor...

You can test the TPS, it is 1 volt with the throttle at idle. I think you can adjust the rod between the TPS mount and the pump to adjust the voltage.

Thanks for the tips. I will work on them this weekend. I did use a laser infrared and the temp was only 145.

I am a new owner. I have a 100kmiles 95 4x4. It has been doing strange things as far as shifting. I changed the tps. It is some what better with the new tps. The trans temp light comes on some times, I am going change it on Saturday. At times the o/d light has come on by its self and won't go...

My friend bought a 6. 7 4x4 12k miles. The book says we need to change the front and rear end grease. We can't find what kind of oil to buy or if any additives are needed. Also is there any need to use synthetic oil in the engine? Thanks Jack

Hi How do I wire a converter switch for my 2gen 1995 4x4. I can't find the wiring set-up to lock up the converter. I know I have read where people have talked about it. :) Thanks for your help Jack