Search Results for Query: *

Try this link http://www.car-part.com

95 2500 CC 4wd 2010 freightliner Sprinter 72 GMC suburban

Joe , that should give you a baseline $ probably vary regionally. To bad your not in Illinois fox could probably get the job done for a couple hundred bucks! The gutter brushes and gutter fill probably work ok but they trap a lot of debris. I've seen them in gutters before and thought the...

Joe, covers are great if you don't want to clean them, or in your case of not being there. there are many different covers... screens will allow the most water to flow into them but also snag certain tree droppings and occasionally need to be cleaned. I prefer a ridged flat periforated aluminum...

5" seamless aluminum K style gutter with hidden bar hangers every 2' screwed into the fascia board... about $8/ft installed... make up around 80% of the guttering in the northeast.

Ok... I need to replace the radiator on my 95 2500... are all the aluminum/plastic tank radiators created equal? probably not... any recommendations???

That"s a great price. , I'll keep that in mind for future parts, thanks. as far as gasket sealer that's controversial as you can see in the thread above..... any one else?? Derrick

I got #7 through my dodge dealer... part no. 5003481ab... list $64. 70. #8, I ordered but have not received yet through a cummins dealer on the internet. Napa, I'm not sure? Derrick

OK thanks! Derrick

Hi Mike, Could you get a part number on a rear pinion seal for my 95 2500 4x4 vin...1sm162566. Thanks so much for your help! Derrick

Well alright then... i am done with oil all over my engine. I hear you on the RTV i get nervous of that stuff getting down to the oil pick up an clogging it up. good advise. . thanks

Thanks for the replies... and the part number, Mike are these gaskets not meant to be reused? Derrick

I had a oil leak at the oil cooler... pulled it and got the gasket at the block to the oil cooler to replace... there is another gasket (Hard plastic) between the cooler and cover... I didn't get a replacement because it looked ok, now i'm second guessing should I replace that too, how about...

Thanks guys for pointing me in the right direction. I'll check those lines and the shop manual has some tests for the switch and shift motor. Awesome help! thanks again

Last night as i was pulling out on the beach for some surf casting my 95 dodge 2500 came out of 4 wheel, the dash indicator went off and the truck began to dig in. I was able to drop the rear tire pressure down to 15 lbs. and back off without getting totally stuck, but I wasn't able to reengage...