Search Results for Query: *

I just installed the Sylvania Silverstart zXe bulbs, xenon halogen, very bright, if switching to those is an option for you.

Mine did not rest against the connector, it rested against the wires, which will wear faster. If you start two inches of wire loom/wrap by the stud the ground is connected to, where you can reach better, wrap end in tape, feed the loom up the ground four inches, wrap in tape, and repeat, you can...

So I did end up checking out my co-workers truck, same as mine but a 2500, 2003 four door, 4wd, long bed, auto, single rear wheel. He has the same un-insulated braided ground wire rubbing on the wires of the top connector. I felt the wires going to the connector and the insulation is starting to...

I think I am the third owner of this truck. I do not know the repair history. I did not see any prevelant means to secure the ground wire. I am waiting for a coworker to drive his 2500 in, same year as mine, and another to check his truck, so I can verify what condition their ground is in...

Got it all wired back in. About two hours of driving over past two days. No issues, no trouble codes. It was real easy to put a 1/2" wire loom around the ground wire that caused this. I would suggest anyone else with a braided, un-insulated ground wire to do the same. A friend at work has almost...

This one has 11. Decided to cut it out and repair it. Only one wire had a couple strands broken, soldered it solid, then put shrink tube on all wires that the insulation burn. Epoxied everything shut with a two part 'plastic bonder' epoxy. Hard part will be wiring it back into the harness with...

Closer pic.

This pic should show location. It is looking towards the front of the vehicle. The bolt heads in the foreground are for the trans fluid pan. You can see where the ground wire attaches to the body on the left (drivers side). There are two connectors mounted on the bracket. The one that shows the...

It was secured properly.

I was idling truck (2003 3500 SO engine, auto) unloading some trash, noticed an electical fire smell, and sure enough, it was my truck. Went to cut engine off, noticed gauges were haywire. Not much smoke, opened hood, saw small flame on drivers side behind the engine. Quick squirt from fire...

Cj, Did you ever get around to experimenting with motor oil or hydraulic oil? Anyone got any links to some good info on either?

I have the full version of the Torque app ($10) with the PLX bluetooth OBDII connector ($100). I am still learning my way through the program and just recently got my Ram, but has been very helpfull for my Toyota, fixed the cold start problem by showing me a sensor that I had overlooked was bad...