boost

Hey guys, alright so I recently just installed compounds on my 98.5 24v. I got everything installed double checked all hoses and oil lines. Started the truck and tried to drive it, I’m getting absolutely no boost and after about 3-5 mins of driving around the block my turbos we’re smoking. I...

'07 5.9, g56, bone stock setup w/ gauges. So, I've been trying to chase down a boost issue for a while now. Initially replaced a leaky boost hose and added an autometer boost gauge w/ boost bolt in the intake. When I drive, I'm only reading ~4-8 psi unless I punch it going uphill which will get...

I have noticed that over the was few weeks I am only getting around 5psi of boost pressure per my gauges. The truck starts and runs good but lacks power when trying to pass someone or when pulling anything. At a stop light, the boost pressure drops down to about 1 psi and at 60 it is at the...

Can anyone tell me what frequency the PWM signal is sent at to the boost solenoid?

Was fiddling around with truck today, and decided to bump fuel plate forward a tiny bit, and as I was moving the AFC out of the way, the plastic boost pressure line just fell off. It is broken at the brass nut. Grrrrr. Anyone have a quick fix for this, or am I going to have to call Dodge or...

Well Im not sure if this is where is belongs and I couldn't seem to find it any where else, but I have a few questions about wiring my new gauges in. I am hoping to get some advise about how you may have installed your gauges. -My first question is how do I tap in to a wire that will dim the...

the thing is, my stock turbo went down broke the shaft. i have a perfect good to4e lying around but its very small i think but how if i build it into a compound with a hx50 or hx52 the only info on my to4e garret is air/research60 i think or somthing like that ive read. or please give me...

hi im pretty new on this site and the other day my shaft went down in my stock turbo. now i dont really know what i should put there im on a little tight budget the car is a 2005 dodge ram 2500 5. 9dsl autotranny my mods is deleted cat and a smarty pod and when my pocket is filled up...

Part 3 Boost and pyro loomed and secured. Trans temp sensor mounted to cooler line. I works quite well. Interior view... I really like watching these gauges work. I now take the hilly way home to watch my waste gate work. Done. Took about 7 hours, but that...

Part 2 After the first hole was drilled and then the magnets cleaned and replaced on manifold. When the last magnet is removed, the remaining chips "jump" on it, leaving the manifold fairly clean. Hole 2. Hole 3, the final hole before tapping. I thought the tap would...

I wanted to document my Isspro gauge installation - Pyrometer, Boost, and Transmission Temp - and fill in some of the "holes" that I found when I searched the forum prior to beginning the work. I ordered a Diesel Manor kit with everything and was very satisfied with the quality and...