engine

This is the second 2005 Cummins Manual Trans to have this issue that we have seen. We are familiar with the (normal) if you will surge/hesitation on a decel that you see while doing a wide open throttle snap. (Usually amplified by high return issues). This is different. This customer has...

12 valve Cummins motor with under 15k miles. TURBOS NOT INCLUDED (sold). Runs perfectly and makes great power, still reliable on the street. Only the block is used, bored 20 over and decked, all other parts are new and motor was properly balanced: NEW Crank Cam (stock) Pistons and rods Harmonic...

I have a 2016 ram 3500 with 50,000 miles that I use to haul a truck camper and pull a heavy boat. I drive up and down the same grade fairly often. Sometimes the engine brake works, other times it doesn’t. This issue has been going on for about a year and it never throws any codes or has any...

I have a wrecked 2005 Ram 2500, auto, diesel. I've put a few dollars into transmission, input, Gorend conv., flex plate etc. The truck has just over 70,000 miles. I'm going to have somebody pull the engine, I've been "carrying" this wreck with me for 10+ years and I cannot store it anymore...

Hi, I bought this truck with 14,000 miles and I have serviced it regularly, using oil testing during driving. I have a logbook of service and maintenance. I put a bunch of money into the transmission Gorend conv., billet input, shift kit, bigger pan, good flex plate. I put another turbo on it's...

Have a 2000 5.9 with 170k. Given the age I’m concerned that pulley bearings are going to fail soon. Given I tow a camper with the vehicle, trying to avoid future roadside issues. Looking to do the work myself but looking for any/all guidance. If anyone has docs/pics to share or can direct me...

Hello. The truck is a 2012 Ram 4x4 diesel auto with 160K miles. No matter hot or cold temperatures the issue persists. With engine running and hi beams applied, there is a temporary hiccup in the electrical system. Whole electrical system will shut down for a split second and then pop back on...

I have been chasing an engine vibration in my 05 4x4 6spd H.O. short bed quad cab for about 6 months. It varies but most noticeable at 2,000 to 2,400 rpm and at idle. Truck has 135K on it. I tow a 6 ton equipment trailer and plow with it. Had an injector coil fail around 90K and replaced that...

I have a 04. 5 motor that I was parting out and have some stuff left that I just need out of my garage. I have block with main caps,cam,rockers push rods, wiring harness,oil cooler,front cover,exhaust manifold intake, and other odds and ends,500. 00 obo. make me an offer. also have pistons and...

I have a 94 Dodge with 230,000 miles on it. My truck idles fine until it warms up and then it has an engine miss at idle that seems to clear up a little at higher RPM's. I can't tell if it's lost much power and there is no smoke coming out of the exhaust. It seemed to happen after I filled up at...

Last week started truck up in a hurry backed out of garage and the engine slightly stumbled but I noticed it. Ran it lightly loaded all week, ran a. c. on Friday. Yesterday started truck and went out. About 5 mi. from home it started skipping. Not smoking at all... (Tromp on it smokes black...

My 2007 has 91K on it now and I start it every day, change oil every 4,000 miles. Just recently have noticed a new noise that sounds like a moderate grinding humming noise. Not really sure what it is, I bought a stethoscope and did some listening around with it in the belt tensionor, water pump...

I replaced both my batteries today, and now the check engine light is on #@$%!. I called the dealer and they said to unplug the batteries and let them sit and the light might go off. I did this and the check engine light is still on. I do not have a code checker, but I am wondering if anyone has...