gauge

I did a little searching and haven't found this in any previous threads; hoping you guys can help. With everything working correctly, last week I pulled the dash for an overdue replacement from LMC. I pulled the clear shield off of the instrument cluster to wipe down the gauge faces and clean...

Hi there, My early 2004 gauge cluster has an RPM needle with a mind of its own. Typically fails when it gets hot out in the summer. I reflowed the solder several years back and that seemed to help but now its really bad. Since my truck is a 6 speed, the RPM gauge is nice to have. Do you guys...

I have a 1999 Dodge 2nd generation.5.9 diesel. Got back after a trip, 2 days later the batteries were dead. Replaced batteries, alternator, and no success. When you turn the truck on and turn off all factory gauges stay energized. And when you (jiggle) turn key on and off they go to zero. I...

So I’m having issues with my oil pressure sending unit and from research I’ve heard that the stock one isn’t the most reliable. I’ve also heard that putting one at the top of the oil filter housing reads higher pressure than the stock position. Some other people in other post have talked about...

Airbox is gone, Cleaning out my garage and need to get this stuff out of here. I have my stock airbox, and stock "A" pillar cover. I have a two gauge stering column mount. I also have my stock suspension with under 2K on it. Free to good home.

I'm looking at getting a 3 guage cluster for my 98. 5 24V CTD, which has the tach, oil pressure, coolant temp, volts in the stock instrument panel. I am going to do my first heavy/long haul in early May, and I am thinking I want at least the transmission temp and pyrometer, but I'm undecided on...

For sale is a black sport comp 30 psi electric fuel pressure gauge black face with snubber. Paid $240. 00 new, selling for $87. 00 shipped in usa. No brackets to hold in flange mount as i had it in pod, sending unit, leads etc. All there. Prefer pay pal SOLD!!

Sport Comp Black face with snubber 0-30 psi, do not have rear bracket for dash mount as it was slipped into a POD. $85. 00 shipped in USA SOLD! Pay Pal preferred

analog gauges vs. Edge Insight for 1998 12-valve 5-speed Greetings all, This is my 1st posting to the TDR threads after perusing them for many months. I have a 1998 2500 quad cab with the 12-valve engine and NV 4500 manual transmission. I am looking to get some gauges to monitor systems when...

So, I've had a FASS 95 installed on my truck for over a year now. It still has the original filter and separator on it with about 10000 miles racked up. My issue is the fuel pressure gauge originally started at 17-18 psi from the NPT fitting on the FASS pump and stayed put for a good chunk of...

Part 3 Boost and pyro loomed and secured. Trans temp sensor mounted to cooler line. I works quite well. Interior view... I really like watching these gauges work. I now take the hilly way home to watch my waste gate work. Done. Took about 7 hours, but that...

Part 2 After the first hole was drilled and then the magnets cleaned and replaced on manifold. When the last magnet is removed, the remaining chips "jump" on it, leaving the manifold fairly clean. Hole 2. Hole 3, the final hole before tapping. I thought the tap would...

I wanted to document my Isspro gauge installation - Pyrometer, Boost, and Transmission Temp - and fill in some of the "holes" that I found when I searched the forum prior to beginning the work. I ordered a Diesel Manor kit with everything and was very satisfied with the quality and...