Here I am

getrag

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. N

    Getrag Replacement Suggestions?

    I've been waiting over 29 original years and 77,000 original miles to replace the Getrag in my '92 W250 Ext. Cab. I was a TDR member decades ago but drifted away. Does anyone know of a shop that can swap out the Getrag for something less defective - preferably a shop that takes an interest in...
  2. D

    First time having trouble with the getrag.

    92 d350 5spd 2wd new to forum and learning how to coordinated and what the "SOP's" are. But having some issues with the ole' 5 speed and don't want to give up on her just yet.
  3. Brandonx286

    Getrag 1-2 synchro ASSEMBLY

    Having a hard time sourcing the 1-2 synchro assembly for a getrag 360 since it's been discontinued. Anyone have a source for them, or an extra laying around? I've already checked with Allstate, Midwest, torqueking, standard trans, eBay, etc. none in stock. Thanks
  4. C

    92 W250 4x4 Flatbed single cab

    Single cab, getrag manual transmission No rust. 131k miles are accurate Rebuilt front end with crossover steering and 2.5 soft ride leaf springs, borgeson steering shaft. 2nd gen turbo, small increase fuel pin, 3200 governor spring, timing spacer. Boost, egt gauges, 4” exhaust, performance muffler...
  5. G

    Getrag 360 jumps out of 1st.

    Hello... Kind of an obscure question to put forward it seems as i haven't even found a hint on a internet search. So i'm looking at a 1993 Dodge D350 with mini dump firewood truck that's seen some hard bush work. The relatively low mi. 5.9 runs like a champ but the transmission on the other hand is...
  6. C

    rattel from clutch fork

    I just had my getrag rebuilt, installed it and noticed a small clicking/rattle noise in every gear and neutral with the clutch completely released, the noise will go away with any clutch pressure or if I hold on to the fork under the truck, the slave keeps a small amount of pressure on the fork...
Back
Top