injector

I have a 06’ 2500 2wd. I recently put a lot of work into it and I plan on getting EFI live but I’m curious as to what are my potential numbers I could pull with these mods. mod list, Stealth STR turbo (47ish lbs boost) ATS proflow manifold Banks intercooler system with horn (3.5in tubing)...

Has anyone experienced the DEF injector fasteners rusted ? My 2015 needs the nozzle cleaned but the nuts on the studs have almost completely disintegrated , has anyone had any luck with replacement studs or nuts , I'm a bit worried to attempt removal ,and not have what I need to reattach . The...

This may be a stupid question but I wanted to run it by folks here before I bring my truck in to the shop. I adjusted my front band on my 04.5 3500 (48RE) earlier this summer. I followed Dodge specs and backed the screw out 1 3/4 turn after tightening to 72 in lb but the shifting was a mess. I...

Here is a nice writeup from BBi how to find out about the crap that is out there. https://www.bigbanginjection.com/why-to-avoid-chinese-injectors/?gclid=EAIaIQobChMIjPbW4LG18AIVFRd9Ch2oWAE6EAEYASAAEgK48_D_BwE

My truck has had a badly running engine for a while. It's like something is loose in fuel system (or something else) I thought it might be fr the AFC live I've put in, it allows you to adjust the AFC from inside can, on the fly. So I've been meaning to take it in (good diesel mechanic in Sac...

I bought a 2006 ram megacab with 5.9 from the dealer this past Saturday with 225k. has a K&n intake, mbrp exhaust, and a powermax CR TST. test drove it drove amazing with no problems. Took it home and drove it all day and night without a single hiccup. The truck did have what seemed like a...

I have a 2004 dodge 3500 Vin C. I replaced the injectors because it was blowing white smoke and missing out, plus the dealer said they were over flowing lol. So I bought remanned ones which was a mistake but now it doesn't do anything but blow black smoke from low end to top end speeds. It also...

I installed an Air Dog pump and my fuel pressure gauge shows 12 PSI, but when tested it shows 16 PSI. The pressure drops minimally if at all when towing. However, the engine often acts like it is fuel starved. The fuel pump is good and filters were just changed. Air filter was changed. VP44 was...

I think about to replace my injectors precautionary, they are 130000M old and I dont know about the past, injector rattle is present especially uphill with 3/4 load. So i think it would be best to change them and dont get stranded out in nowhere. New Stock Bosch would also be a choice, even...

Last week started truck up in a hurry backed out of garage and the engine slightly stumbled but I noticed it. Ran it lightly loaded all week, ran a. c. on Friday. Yesterday started truck and went out. About 5 mi. from home it started skipping. Not smoking at all... (Tromp on it smokes black...

hi ive got my new ss injectorbodies woth flux2 nozzles some hours ago and the problem is i dont really know how to install them have no torque specs is it any guide out there to read some months ago i found one on some forum with pictures and how har du tighten every bolt but cant find it...

to make the story short my 2005 dodge ram will not start or sometimes it will but with a litle spray in the intake i can get it running. it has a rough idle and sometimes i think its missfiring on some cylinder. how to know if its a pump. pressure valve or injector failure? i looked around...

Had this problem for awhile but it is getting worse. With slow acceleration and/or not hauling anything truck seems fine. Under moderate acceleration or if towing or hauling any load the engine will cut out and blow a puff of smoke out the back. Sometimes it will make the same noise under the...

2001 HO 6spd. 3. 55 gears Edge drag comp Mach1 EDM 3. 4s Super B turbo BHAF air filter 4" downpipe straight to 6" stack Dyno 450rwhp 1025rwtq Weight ~8k lbs. When pulling ~8k lb. trailer for instance... it gets way hot on EGTs - way quick. I'm tired of fighting it... it's been a...