pcm

Hello everyone, just joined here in hopes of finding a solution. I have a 2005 Ram 2500 cummins. I had some problems with the accelerator pedal ( response is way off and it feels like the truck is having a fuel cut ).. codes are: P2121 & P2128.. (other codes of wastegate solenoid and map sensor...

Ok guys ive got a 07.5 3550 with 325500k and a 68rfe. A week ago i got the p0750 code for the shift solenoid. I did all the resistance testing and volt testing and determined it was the solenoid pack. So i changed the solenoid pack, fluid, and filters. That code never came back but a low voltage...

Had a bad ECM. Replaced with a RECON ECM coded for my truck. After install there is no power to Relays in PDC. Lift Pump is inactive. Getting Powertrain codes P0380, P0380 P, P0382, P0382 P Not getting 5 volts from PCM Violet wire with White Trace. Engine turns over, but won't start. Anyone...

i am new to forum please advise or point me in the general direction of credible information regarding what all is required to perform correctly the upgrade from v10 to 5.9 cummins... as above my 1999 ram 2500 4x4 factory equipped with automatic trans and v10 engine..let go ! under extreme use @...

Good afternoon! Are there any Techs out there that are familiar with the subject?. I've been dealing with the subject referenced codes for about 5 years now. All this time, I was pretty certain it was the TIPM, more than likely because of all the reports out there about problems some folks have...

Hello. My dog went after a critter under the hood (i left it up) and pulled the pcm harness completely out. This caused all 3 connectors to be pulled apart. I have located pcm connectors and partial wiring (cut out of 98) and purchased on eBay. My question is how to proceed? Attempt to replace...

Three days ago, I went to town (35 mi) with no indication of trouble. When I tried to start the truck later, the batteries were completely dead. I had a truck hooked up for about half an hour before the charge allowed me to start the truck. After starting there was no electrical service...