replacement

I've been waiting over 29 original years and 77,000 original miles to replace the Getrag in my '92 W250 Ext. Cab. I was a TDR member decades ago but drifted away. Does anyone know of a shop that can swap out the Getrag for something less defective - preferably a shop that takes an interest in...

I had to replace my water pump today on my`07 (5.9L) that has 65k miles on it. My truck has not been my daily driver since June 2014. It is primarily a garage queen these days, so I suspect the pump failed partly due to lack of use. The bearings were fine, the pump was not noisy, the pulley...

Our 2014 started spotting on the driveway more than the dealer residue from oil changes. So I rolled under there and noticed half the underside of the truck covered in trans fluid. This appears to mostly be centered around the junction block on the right of the bell-housing, though a lot of the...

I have a 2007 F550 with the 6.0 liter engine (approx 82,000 miles on it). I use it to pull a 18,000 lb GVWR 5th wheel toy hauler RV. Two weeks ago while traveling from New York state to Colorado, the exhaust tube on the turbo popped off at the turbo end. I had a diesel mechanic re-attach the...

Symptoms: 98 12v: A couple of weekends ago I was pulling a trailer full of metal roof over the mountains. I had no problems go and coming half way back over substantial mountains. Then, about 2/3s wary home on one puny incline I noticed a loss of power even with full throttle. Following that I...

Looking at replacing the exhaust manifold on my 2003. Looking for peoples opinion on who makes the best replacement. Having an existing port for egt sensor would be a nice feature. And did you install it yourself? If so how complicated was it. Thanks

I am looking for a complete Cab to replace my failing 99 quad cab. Must have doors, glass, mirrors, dashboard, steering wheel Any color, any trim level. Prefer from a manual transmission (mine is a 5 speed) Prefer from a CTD Prefer complete with matching interior Will consider trucks with...

After reading a number of threads, I've decided that I'm getting too old to fight the front axle u-joint replacement (at 140k miles). Although the u-joints are no big deal, the bearing hub disassembly looks like more that I want to deal with... I'm looking for a shop in St. Louis that will...

the thing is, my stock turbo went down broke the shaft. i have a perfect good to4e lying around but its very small i think but how if i build it into a compound with a hx50 or hx52 the only info on my to4e garret is air/research60 i think or somthing like that ive read. or please give me...