transfer case

Having a hard time finding where this broken vacuum line goes. The white one obviously goes to the transfer case, and I will patch that. But what about the black one off the side?

I was driving across Idaho towing 10k when I hit a bump in the highway and a grinding noise started. I pulled over, got out and checked to see if I was dragging something or if there was obvious damage. Everything looked fine so I got back in, put it in gear and started driving and immediately...

I am hoping that you kind folks can help a neophyte out. I have a 2010 Dodge 3500 DRW Cummins truck. After 170k, she finally left me on the side of the road. Got her home and was told but people that i thought had more smarts than me that it was the rear end. It was not but i went ahead...

My truck is an 03 2500 4x4 with 6 speed. 277,000 miles. When pulling hard in 4 wheel drive ( like pulling someone out of the mud), I get a loud popping or ratcheting sound and the truck jumps a lot. The u-joints are good, and everything up front appears fine. I’m suspecting the chain in my...

All, on the full 4x4 service two weeks ago my mechanic found the fill plug at the top of the transfer case had the socket really messed up and very difficult to get the tool inserted to remove it. He got it out and cleaned up the tool socket. He re-installed it but it needs to be replaced...

Transfer case attempting to engage 4 low after key is turned off??? 2006 3500 5.9 You can hear it attempting to engage. any insight? I'm an old guy not used to these boards, so excuse me if this has been discussed before. I couldn't find anything with my searches. Please, I need help. Thanks kevin

Newbie to this forum Own 93 4WD extended cab - need part in transfer case (Model 205 D6,7) shift assembly - #R52077911 - ID "13" in attached image ..... probably could use #14 as well

So I did a clutch job my truck and I broke a vacuum line for 4x4. I got some vacuum hose and fixed the line. We got a huge snow storm today and the 4x4 dash light comes on and off as it should bht nothing happens.. Its 2 wheel drive regardless. Not super fromiliar with these systems so any info...

Truck profile/history: 1998 12 valve, about 800hp/ 1600tq with twins, 4wd, extended cab, long bed DTT built automatic trans with billet input/output Stock light duty transfer case, never been opened or serviced Nearly 300k miles with 500+/- ¼ mile passes with high-boost launch in 4wd, lots...

I have a 2005 with the NV273D electric shift transfer case. The shift motor stopped working and I replaced it with a new OEM unit and new ends on the wiring harness. New shift motor works fine hanging under truck plugged in but not bolted on. Transfer case shifts fine with crescent...

I have a 2013 Ram 5500 that I use for transporting. I recently roled 105,000 miles and needed four wheel drive at a job site I was delivering to when I shifted into 4WD and started to move the truck it started this grinding noise it sounds like a chain slipping on a sprocket. Has anyone else had...

I have the dynatrac front hubs and a few days ago my "serv 4x4" light came on and I cannot get the truck into four wheel drive. I am often using 4 Hi and 4LO for work in the outback. I suspect it might be a bad sensor or plug gunked up with dirt but if it is something more serious and I need a...