transmission

Apologies in advance if this question has been asked and answered. I looked and didn't see this specific issue. I recently had a jasper automatic transmission put in my '98 3500. This weekend was the first chance I've had to really drive it and test it. Hooked to an enclosed trailer with OD OFF...

Full billet 47RE, all the goodies, rebuilt with new billet shafts less than 20k miles ago. DPC triple disk converter rebuilt less than 20k miles ago. SFI flex plate, maybe 50k miles. This transmission can handle high-boost 4wd launches, but has only done one burnout since rebuilt. Upon removal...

Transmission wants to shift from 1st to 2nd but then instantly kick down back to first I know it shifted by feeling it and watching rpm drop like it shifted. But only can get it to do if I get 3000rpm or higher any lower it want even try to shift. Anyone can can help?

Has anybody had their auto trans done in Sacramento area, and is happy with their "beefed up", high hp/torque transmission? Ken Imler,who is a high performance person here says he uses A1 transmission, which I think is in Ga. If I have to send it there, I will do so, but I have to take all my...

So I just ordered the Smarty s03 programmer for my 2002 Cummins after hearing many great things about it, currently running the Edge EZ that was on the truck when I bought it. I'm curious what best level to run the tune on my stock automatic 47RE transmission (which are obviously notorious for being...

I have a wrecked 2005 Ram 2500, auto, diesel. I've put a few dollars into transmission, input, Gorend conv., flex plate etc. The truck has just over 70,000 miles. I'm going to have somebody pull the engine, I've been "carrying" this wreck with me for 10+ years and I cannot store it anymore...

I've been waiting over 29 original years and 77,000 original miles to replace the Getrag in my '92 W250 Ext. Cab. I was a TDR member decades ago but drifted away. Does anyone know of a shop that can swap out the Getrag for something less defective - preferably a shop that takes an interest in...

I had a look today on what it's going to take to drain and refill the power steering system on my 1996. (It's pre-hydroboost.) The job looks messy and involved enough that I figure that while I'm about it, I might as well install a power steering cooler. I already have a Derale 1312 power...

Hello all, this is my first time posting here, and I'm relatively new to owning a diesel truck, so please bear with the FNG. I own a 2006 2500 mega cab, with a 5.9 and a 48re. Earlier this week I was driving through town and the trans completely let go with very little warning, I'm fairly...

Hello, I’m new to this forum and couldn’t find anything about this, I have a 2012 Cummins 200k miles. Keep in mind the truck as never been tuned in anyway. It’s completely stock and has been its whole life. Another note is the truck has not pulled any crazy loads. But next summer I’m taking 2...

So I have a 2008 cummins with the 68rfe. I was driving home on county roads after work one day and truck went from fine to shifting weird in an instant. Tried making it to the top of a hill but it was stuck in limp mode and over reving I'm assuming caused transmission fluid to blow out of...

Ok guys ive got a 07.5 3550 with 325500k and a 68rfe. A week ago i got the p0750 code for the shift solenoid. I did all the resistance testing and volt testing and determined it was the solenoid pack. So i changed the solenoid pack, fluid, and filters. That code never came back but a low voltage...

Hello everybody, I am a new member, thanks for adding me. I just bought a 2017 RAM 3500 dually, I just found out it has a (68REF transmission) I didn't know about the Aisin trans. I want to use the truck for car hualling with 4 cars trailer. Do you know if the 68REF will do the job? Should I...

I have a wrecked 2005 single cab. I had it since it had 14K miles and it has about 80,000. I kept it up well, oil analysis, oil changes, etc. I wrecked the driver side and the driver side wheel broke off and it ruined the hood and drivers door. I always thought it would be too expensive to fix...

Having a hard time sourcing the 1-2 synchro assembly for a getrag 360 since it's been discontinued. Anyone have a source for them, or an extra laying around? I've already checked with Allstate, Midwest, torqueking, standard trans, eBay, etc. none in stock. Thanks

not looking to start a war...... I need recommendations on either a replacement (comapny) or rebuilt (recommend company parts to have local shop rebuild) 47RE for my 1998.5. I've got 110kmi on a 21 year old truck that was never abused, hauled a 1965 Mustang GT Fastback to LA :( and a small...

My truck is not my daily driver. I start it and let it idle up to temperature about every 2 weeks. A couple of weeks ago I noticed an bad smell when truck was idling. I went to take truck on a trip Saturday and after a few miles I had to back into a driveway and had no reverse. I went to...

Please help! The emergency brake light and ABS light keep coming on and turn off regularly. A few months ago I Reflashed the ECM Re- did the brakes and replaced a sensor because I was loosing braking power and they would lock up on me. All was good for a month, no lights coming on. Then the...

Just this week, I decided I’d throw a little love at White Lightning in the form of a PML AS69RC Deep Transmission Pan. https://www.yourcovers.com/transpan_11142.php I ordered it Sunday night, and it arrived today. I’m currently at 102,400 miles, but 120,000 miles will be here before ya know...

I just finished a cross country trip from Florida to California pulling a trailer that weighed about 4,500 lbs. The truck has a firepunk street/track transmission and was operating around 144 degrees before the trip in 90 degree weather around town and cooler on the highway. Today I noticed the...