WIRE COLOR LOCATION POL.
Battery 1 Large Red Ignition Harness Pos
Ignition 1 Pink/Green Ignition Harness Pos
Ignition 2 Pink/White (5) Ignition Harness Pos
Starter 1 Yellow Ignition Harness Pos
Accessory 1 Large Blue Ignition Harness Pos
Accessory 2 Small Pink/Yellow Ignition Harness Pos
Parklight Negative White/Lt-Green (1) At Light Switch Harness [270 ohms] Cut
Brakes White/Tan At Brake Switch [Above Brake Pedal] Pos
Horn Black/Red At Steering Column Neg
Glow Plug [Program wait time] (Program wait time)
Tach Dk-Blue/Red At PCM Module [Engine Comp. ] (9) 6Cyl.
Lock Purple/Green (2) Drivers kick Panel [850 Ohms] [Neg] (6) Res
Unlock Purple/Green (2) Drivers kick Panel [400 Ohms] [-] Res
Disarm Purple/Blue (2) Drivers kick [400 Ohms] [-] (4) Res
Rearming Purple/Blue(2) Drivers kick [2 K Ohms] [-] Res
Dome Sensor Yellow (3) At Dome Light [Under Dash] Neg
Key Sensor Lt. Blue Steering Column Neg
F. L. Door Pin Tan At Connector At Keyless Module Neg
R. L. Door Pin Purple/Orange At Connector At Keyless Module Neg
F. R. Door Pin Tan/Red At White Conn. in Passenger Kick Neg
R. R. Door Pin Tan/Yellow At White Conn. in Passenger Kick Neg
Comments :
Note: This vehicle is equiped with a TRANSPONDER system that needs to be bypassed, use Astrostart OM-Chrysler-1 (P/N 310-907-514).
(1) Pulse with a 270 Oms resistor by opening the circuits , See Diagram.
(2) These wire can be found into the harness comming from the driver's door, Or into a White connector under the driver's side dash
(See picture for more info)
(3) The Door pin at KeyLess Entry: Tan for Driver door (-)
Purple/Orange Rear Left Door (-)
At White Conn. in Passenger Kick : Tan/Red Passneger Door (-)
Tan/Yellow Rear Right Door (-)
You will need to isolate door pins if your instaling a 3106,,,,,,
(4) 1 pulse desarm only, 2 pulse desarm and unlock!
(5) Need to be power up before the ignition!( Becareful two Pink/white wire may exist at the ignition switch, but only one act as ignition)
(6) If you have factory alarm, use only the Purple/Blue to Arm/lock and desarm/unlock!
(7) On the 5. 9l engine the tach is black/gray (8cyl) at coil
(8) If not power up the ABS and the brake lights will stay on!
(9) Dk-Blue/Red, Pin 24 on plug toward the front ,closer to radiator at PCM Module.
(10) You'll see a solenoid on Passenger side inner fender (engine compartement) use the White (+) wire on it!
Battery 1 Large Red Ignition Harness Pos
Ignition 1 Pink/Green Ignition Harness Pos
Ignition 2 Pink/White (5) Ignition Harness Pos
Starter 1 Yellow Ignition Harness Pos
Accessory 1 Large Blue Ignition Harness Pos
Accessory 2 Small Pink/Yellow Ignition Harness Pos
Parklight Negative White/Lt-Green (1) At Light Switch Harness [270 ohms] Cut
Brakes White/Tan At Brake Switch [Above Brake Pedal] Pos
Horn Black/Red At Steering Column Neg
Glow Plug [Program wait time] (Program wait time)
Tach Dk-Blue/Red At PCM Module [Engine Comp. ] (9) 6Cyl.
Lock Purple/Green (2) Drivers kick Panel [850 Ohms] [Neg] (6) Res
Unlock Purple/Green (2) Drivers kick Panel [400 Ohms] [-] Res
Disarm Purple/Blue (2) Drivers kick [400 Ohms] [-] (4) Res
Rearming Purple/Blue(2) Drivers kick [2 K Ohms] [-] Res
Dome Sensor Yellow (3) At Dome Light [Under Dash] Neg
Key Sensor Lt. Blue Steering Column Neg
F. L. Door Pin Tan At Connector At Keyless Module Neg
R. L. Door Pin Purple/Orange At Connector At Keyless Module Neg
F. R. Door Pin Tan/Red At White Conn. in Passenger Kick Neg
R. R. Door Pin Tan/Yellow At White Conn. in Passenger Kick Neg
Comments :
Note: This vehicle is equiped with a TRANSPONDER system that needs to be bypassed, use Astrostart OM-Chrysler-1 (P/N 310-907-514).
(1) Pulse with a 270 Oms resistor by opening the circuits , See Diagram.
(2) These wire can be found into the harness comming from the driver's door, Or into a White connector under the driver's side dash
(See picture for more info)
(3) The Door pin at KeyLess Entry: Tan for Driver door (-)
Purple/Orange Rear Left Door (-)
At White Conn. in Passenger Kick : Tan/Red Passneger Door (-)
Tan/Yellow Rear Right Door (-)
You will need to isolate door pins if your instaling a 3106,,,,,,
(4) 1 pulse desarm only, 2 pulse desarm and unlock!
(5) Need to be power up before the ignition!( Becareful two Pink/white wire may exist at the ignition switch, but only one act as ignition)
(6) If you have factory alarm, use only the Purple/Blue to Arm/lock and desarm/unlock!
(7) On the 5. 9l engine the tach is black/gray (8cyl) at coil
(8) If not power up the ABS and the brake lights will stay on!
(9) Dk-Blue/Red, Pin 24 on plug toward the front ,closer to radiator at PCM Module.
(10) You'll see a solenoid on Passenger side inner fender (engine compartement) use the White (+) wire on it!