To do the Ford brake conversion, you need everything from the ball joints out. Parts must come from a 92-94 or 95-97 F350. Dodge and Ford used the same ball joints.
Need:
-loaded calipers
-caliper brackets
-rotors
-stub axle (11 3/8 I believe)
-wheel bearings
-stub axle support needle bearings
-U-joint (can reuse existing if good)
-hub lockouts
-seal kit
-ball joint press (might as well replace)
-bearing grease, anti-seize, loctite, penetrator
-sledge hammer
-Bigger Sledge Hammer.
-Torch
-Case of Beer
-Friend Stupid Enough to Come Over and Help.
I'm sure I'm forgetting something.
Need:
-loaded calipers
-caliper brackets
-rotors
-stub axle (11 3/8 I believe)
-wheel bearings
-stub axle support needle bearings
-U-joint (can reuse existing if good)
-hub lockouts
-seal kit
-ball joint press (might as well replace)
-bearing grease, anti-seize, loctite, penetrator
-sledge hammer
-Bigger Sledge Hammer.
-Torch
-Case of Beer
-Friend Stupid Enough to Come Over and Help.
I'm sure I'm forgetting something.