68rfe fluid and filter change

[kjg26]

Just did a trans fluid and filter change. Now I have codes. Fluid lvl is where it needs to be. Truck drives well.

P0841
P0868

Drained overnight . O ring seal in good shape, left original in place, spin on filter on about 3/4 turn after mating surface seated, MOPAR RTV used.

Also interestingly I have codes for the turbo actuator that I had fixed 2 weeks ago. Were not there when I shut off the truck to do trans fluid and filter.

I've tried clearing the codes with the Torque app and bluetooth scanner. Says they're cleared but they never clear. Going to pull neg cables in the AM

Anyone have any thoughts or input?

 

[sag2]

If all you did was change the fluid and filters you need to go back to what you did to break it. Most likely cause would be the o-ring for the primary filter.
Unless you have a large drain pan before you drop it go to home Depot or Lowe's and buy one of the small mixing pans that they use for morter. They're nice and big and you won't lose any of the new fluid. They're only about 10 or $12