Here I am

'89 Front axle

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Uh oh lost a bolt in the engine. What to do

Anyone looking for a 4BT Cummins?

Status
Not open for further replies.

Kiohio

TDR MEMBER
I'm getting ready to tear into the front end on the '89, mainly brake stuff.

My plans are: New: Master Cyl, Calipers, Rotors, Axle Joints, Axle bearings, Pads (duh), All lines. I already installed new shocks.

I will reuse the wheel bearings if they are good.



Anything else I should do while I'm in there? Any hints?

I've been soaking everything in PB for quite a while.



Thanks, KO
 
Check the needle bearing inside the spindle and seals. These are out alot of the times. Most parts stores can get a rebuild kit that has the bearing and the seals in one bag.



Also if there is any slack in the kinpins since you will have it all torn down it would be a good time to rebuild them as well.



Andy
 
I was just looking at the kingpin kit from moog.

Sound like lots of fun LOL

I did pick up the bearings you speak of.

I am hoping to do all of this and not have to touch it for a long time.

Thanks, KO
 
Jeff



Pretty straight forward do all the bearing's while your there, and the inner axle seals,,, all three.



I have both style socket's they used for the frt spindle nut's and also a spindle puller that will make the pulling the axles alot better.



If you have any problems getting the parts or get in there and find you need a spindle or anything crazy give me a call on the cell phone I have some spare parts here at the house if not, I have a guy I can get axle parts from Fast.



Zach
 
Thanks Zach!!

I appreciate it.

I'm sure I will be calling you on the puller adapter.

I was going to start last night but y'know how that goes.

Now we're getting ready for the fair.

Sorry I missed you a few weeks ago.

If you have time swing by at the Hocking County Fair I'll be there with equipment.

I'll be the guy running back and forth on PULL night!



Jeff

AKA Kiohio
 
Status
Not open for further replies.
Back
Top