Attention: TDR Forum Junkies I stopped at Napa and went looking for ball joints , only 2 choises , cheap & higher cost .
Last time I went looking I found that I could get a verity of ajustable upper ball joints , now they only have the 2 choises .
Any suggestions for adjustable , quality , brand , source .
I've read in the TDR mag. issue ? that there was a better spec. to adjust to if you run around with a load most of the time , so the need for adjustable .
Thanks John
I went back to an article in TDR mag. # 53 , about diff. alingment spec.
found part # for those that may be looking ,
Ingall's Engineering , Col.
1-877-858-7272
The #s in the aticle did not come up on there site , looking by apl. came up with a # that had LD at the end so thinking light duty .
Still looking , have to wait till wk day .
Last time I went looking I found that I could get a verity of ajustable upper ball joints , now they only have the 2 choises .
Any suggestions for adjustable , quality , brand , source .
I've read in the TDR mag. issue ? that there was a better spec. to adjust to if you run around with a load most of the time , so the need for adjustable .
Thanks John
I went back to an article in TDR mag. # 53 , about diff. alingment spec.
found part # for those that may be looking ,
Ingall's Engineering , Col.
1-877-858-7272
The #s in the aticle did not come up on there site , looking by apl. came up with a # that had LD at the end so thinking light duty .
Still looking , have to wait till wk day .
Last edited:
