Here I am

2nd Gen Non-Engine/Transmission Axle rebuild recommendation - any good shops?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) Aftermarket Flexplate

Engine/Transmission (1994 - 1998) ATF for a DTT 47RH? ATF + 4 ok?

Status
Not open for further replies.

ChiDiesel

TDR MEMBER
several years ago I swapped gear ratio's, from 3. 54's to 4. 10's. This was due to the fact that when we went camping and offroading in Colorado, we took everything including the kitchen sink and I didn't use the truck as a daily driver. Well now the truck is a daily driver and we are not pulling as much weight and would love to put the old gears back in..... 2k at 60 mph with 4. 10's and 2k at 70mph with the 3. 54's



My question is - can anyone recommend a shop in the midwest that does a nice job on rebuilding axles? I'm located 30 miles west of Chicago.



The original job was done by Chicago Differential and they did a great job, but they are no longer in business.
 
Status
Not open for further replies.
Back
Top