Engine/Transmission (1998.5 - 2002) banjo bolt Question

[Smokin Joes 2500]

OK guys I got my banjo bolt yesterday, from Genos, not sure where it goes. Does it go in the injection pump in the fitting in front of the one with the schrader valve??? Remember Im a rookie. I believe that line goes back along the top of the block behind the fuel filter it then T-s into another line??? Help

 

[BarryG]

I could be wrong here but it takes the place of the schrader valve if you use that location. Another location you can use without losing the schrader valve is to replace the one on the bottom of the fuel filter cannister as it is also post filter

 

[JCyrbok]

BAnjo

It is used to replace the Banjo that HAS the Schader valve in it. The banjo infront of the Schrader is the fuel return line.



BTW check the tapped hole size of the banjo head, I had to retap mine to get it to the required 1/8 NPT.



Make sure that u DO NOT over torque the banjo when u install it and hold the banjo with a wrench when u tighten your hose into it too, very BAD thing if you strip the aluminum threads out of the VP.



Hope this helps.



J-