Bent mudflap brackets

[MSicotte]

I've seen these on a few trucks and don't know where to get them. The top section is stainless steel and is shaped as a regular mudflap. It has a Z shaped brake in it that positions the rubber section of the flap approximately an inch behind the wheel opening. My larger wheels and tires rub on the flaps even on slight turns and the noise drives my crazy (short drive). Anyone know where I can get a set? TIA

 

[Slow Six]

I know the ones you are asking about. If memory serves me correctly the company was from Washington. They used to advertise a lot but I have not seen or heard of them for a few years. When I had my 94 I got some checker plate steel and made my own. They did not look as good as the manufactured ones but they were sturdy and worked good. They kept the flaps far enough back that I never tore them off backing up in snow, mud etc.

 

[RankRam]

I made my own, there are pictures in my gallery.

 

[MSicotte]

Found these, getting the brackets Line-X'd before I put them on, since powdercoating likely won't hold up too long against rocks etc.



SG-LUN1



I bought the SG-LUN1-1 with a 3" set back, should work perfect.