clutch rod fix for NV5600 conversion.

[RonA]

Since the conversion I have had to push the clutch hard against the floor to start engine. The assembly I used for the conversion came out of a 2002. The rod was a little short(5/16"). I finally fixed it today. There are some pictures of the fix in my readers rigs. Kind of crude, but it sure works alot better and engages a little farther off the floor.

 

[GO 4LO]

That's the same thing we did when we put an SBC DD in my 5600 and added a 12V master/slave setup to my truck - so far, no probs .

Chris