Here I am

Engine/Transmission (1998.5 - 2002) Code help

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) Ok whats the next step in performance!

Engine/Transmission (1998.5 - 2002) Two problems

Status
Not open for further replies.
My sons 01 quit this week and we believe it to be at least the LP and at 120K probably the VP44. Fuel pressure on the gauge varies between 1 and 15 on crank. We can sometimes get the truck to start but dies when throttle is depressed. Key up codes P1693,P1691 and P0370. We will be going with Glacier for a pump and suspect a VP44. anyone know what 1691 and 0370 mean?

Thanks
 
1691-fuel injection pump controller calibration failure . 0370 fuel injection pump /position sensor siginal lost. looks like you may need a vp-44 pump. make sure all the connections to the pump are clean and tight. hope this helps.
 
Try first to replace the CPS. It may be the one that is bad, from the codes showing. It's around 50 bucks and readily available.

Ilian
 
ILIANBG, we plan on putting a Glacier on first but where is the CPS? and what is the best source?

Thanks



The CPS can be bought at any dealer or at any Cummins shop. At the dealership I paid $80 but the priced varied from dealer to dealer up to over $120. At the Cummins NW in my area they wanted $36 but I was going camping the next day & it wasn't available until the next day. I paid the $80. . It's located behind the starter. Pull the starter, unplug the wiring from the CPS, & rotate while pulling out. Their kinda a bi%#! to get out but not too bad.



Good luck, hope it's not the VP.



Clay
 
On 01 it should be like mine- right underneath the VP-44, kind of tough to get to. I bought the CPS at the Dodge dealer, about $48, and tried replacing it myself. I couldn't get to it, was frustrated, and took it to the dealer, the guy had it changed in less than 15 min. I think I paid $35 labor. I have receipts.

Ilian
 
Status
Not open for further replies.
Back
Top