2nd Gen Non-Engine/Transmission Does anyone have a contact at Dodge Engineering?

[nwilliams98]

Hi everyone,



I'm doing my thesis on drag optimization of truck canopies using my 97' 2500 4x4 longbed as the test model.



I need a 3-d CAD model of our trucks to run my optimizer over. Does anyone have a contact in engineering at Dodge?



In case its of interest. The project is funded by the Army's National Automotive Center. They are the same people that built the COMBATT version of the Ram that was in one of the TDR mags.



Thanks,

Nathan Williams

nawillia@nps. navy. mil

 

[HC]

Sorry, no contacts, but just in case you hadn't seen this, maybe it will give you some ideas to test out or a starting point for further development:



Water Tunnel test of Dodge



Be sure to share your results with us when you are done!