DynaTrac Seal/Bearing Part Numbers?

[MTaishoff]

About time to repack my front wheel bearings for the first time after installing the free spin kit.



Does anyone have the the part numbers for the Hub Seals from a common manufacturer such as: SKF, Chicago Rawhide, Federal Mogul, Timken etc? Also the part numbers for the Spindle Seals; and all the bearings/races would be nice to have on file too.



When I installed the kit I copied the NOK Seal Part Number that came with it as: AD7408E, but I can't seem to cross-reference that part number.



Thanks,



Mark

 

[JApol]

Look for parts for a 1986 GMC K-30. Thats what Dynatrac told me when I messed up a seal on my install

 

[AMcCormick]

Will dyntrac not sell you parts? I just serviced mine and reused everything. Seals were allmin good shape along with bearings. I do want to replace the lock washer/ring for the spindle nut next service. I was nervous about getting the main spindle seal out from the back side, this is a press fit. I pushed it out from the inside gently as possible to not bugger the seal. I broke everything down. Was actual going to post some pics of. There aree lots of install pics, but I don't think there are any post install pics.

 

[MTaishoff]

Will dyntrac not sell you parts? I just serviced mine and reused everything. Seals were allmin good shape along with bearings. I do want to replace the lock washer/ring for the spindle nut next service. I was nervous about getting the main spindle seal out from the back side, this is a press fit. I pushed it out from the inside gently as possible to not bugger the seal. I broke everything down. Was actual going to post some pics of. There aree lots of install pics, but I don't think there are any post install pics.

I am sure that DynaTrac would; but it would be a lot more convenient to source the parts at the local NAPA/Parts Plus/O'Reillys.



Does the GMC K-30 (Dana 60) have the 1. 5"/35 Spline Axle Stub Shaft like the DynaTrac?

 

[ata]

These are the Part No. that Dynatrac gave me.

LM104949 bearing

LM104911 race

387A bearing

382A race

CR27452 seal

Just go to any parts store and they can cross ref. to any brand bearings races and seals you want.

 

[MTaishoff]

These are the Part No. that Dynatrac gave me.

LM104949 bearing

LM104911 race

387A bearing

382A race

CR27452 seal

Just go to any parts store and they can cross ref. to any brand bearings races and seals you want.

Thanks.



Here are the Part Numbers that the Timken Catalog shows for the Spindle Bearing and Seal:



Seal (Inner): 710044

Bearing: B2414

Seal (Outer) 710045



This is for a 1977-1989 Chevy/GMC K30 with a Dana 60F Front Axle.