Here I am

eBrake shifter switch rattle

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

32K$ for an '03 SRW 3500?

Trcuk Cap

Status
Not open for further replies.
When I have the switch in the OFF position, it rattles. Gets much worse when the engine is up around 2k rpm. Drives me absolutely bonkers :mad: Fortunately I drive with it on almost all the time, so far. But come wintertime it'll be necessary to shut it off in the snow.



Anyone else have this issue? Is there a way to fix it? It looks like the unit is sealed :( Maybe I'll see if I can get a new one under warranty :confused:



Sean
 
Don't know how to fix it, but you just changed my mind on getting one. I have the Napa switch and it rattles too. I was gonna try the stock one, but not now. :(
 
put a rubber band around the shifter and around the knob to hold the switch laterally towards the shifter. I use one of the thin hair bands and it takes care of it no problem and is hardly noticable.
 
yeah, mine does it also... . only on the on position. i know a rubber band would fix it, but i have yet to do it. l... dunno why not. mine is ALWAYS on. unless its raining out. cali highways and the start of rain. . ohh, bad deal with e-brake.

Grant
 
I use a 0-ring that is just big enough to stretch over the shifter knob and around the switch. The 0-ring is black so it is not as noticeable and it lasts longer than a rubber band. It seems that they all rattle. I had a switch from a 2 speed axle on my last truck and it rattled too. At least we have enough power to make things rattle!
 
I have the BD switch, like a splitter switch and it used to rattle. The rubber bands around here dry up and fall apart. I put a dab of grease on the shaft and it fixed it right up. I have to put on a new dab about every time I change oil and grease the chassis anyway. Just use a little, enough to tighten up the seal. This is by far the best fix I've tried.
 
Thanks for the advice :D I'll have a go with the rubber band / o-ring and also try some this spray lube stuff I've got. (kinda like a thick silicone grease) Maybe some of that down in the switch shaft would quiet things down... ... ...





GWBourne said:
... ... ... ... . cali highways and the start of rain. . ohh, bad deal with e-brake.

Grant



:eek: :-laf

Yah, couple of weeks ago I was wheelin' around a corner and the ebrake kicked on over a patch of sand :eek: :eek: :eek: Got a "little" sideways. Good thing noone was behind me or coming the other way.



Sean
 
Status
Not open for further replies.
Back
Top