Here I am

ECM Reflash - TSB Help

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

GOOD wheel alignment shop in SF Bay Area's East Bay?

Hey Piers

Status
Not open for further replies.
I just got my truck back from the shop and they performed a ECM reflash based on TSB 18-015-00. The sticker under the hood now says the ECM part number is 353431304J.

Anybody know anything about this reflash/TSB?

My original complaint to them was that I seem to have less power than I did when I first got it & that after about 1 minute of WOT pulling my trailer up the mountains I felt like I was losing some power. I have 34k miles on it now.

I sure hope I don't loose any MPG because of this! I have been getting 18 MPG at 75-80 MPH on the highway with a little in town driving. Not bad for unloaded with 4:10 gears I guess.

------------------
2000 QuadCab, 4x4, 2500, 6spd, Intense Blue Pearl, No mods as of yet!
 
Something sounds wrong if you need to keep yours wide open for a minute.

I pull a trailer that weighs just under 10,000 lbs up all kinds of grades and haven't ever had to floor it. I'd hate to keep that much pressure on for very long.
 
I have had to since it was new. I have a 7500-8000# trailer (loaded) and when I run up a couple mountains in West Virgina and Virginia and give it WOT in 6th gear at about 70 MPH. It used to slow a little and then hold at 65. Last couple of times I have had to go to 5th and hold at 60-65 (2800-3000 RPM, don't like to take it beyond that).

------------------
2000 QuadCab, 4x4, 2500, 6spd, Intense Blue Pearl, No mods as of yet!
 
Status
Not open for further replies.
Back
Top