Here I am

Archived Edmond, OK. Truck took ten min to turn off

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Archived Transmission died today!

Archived 2004 3500 dually pinion seal PHX

Status
Not open for further replies.
i changed some of the settings on my smarty earlier and at first i got a "can bus" error, but i tried a few more times and got the software to finally finish downloading properly, or so i thought anyway. then i took my truck up the street and back and when i turned the key off and took it out the lights etc went off but the truck remained running. Any help or thoughts?
 
not that i'm aware of. but i only went less than a mile and back and i wasnt hammering on it or anything. i just drove normal. well, for me, that would be somewhere between most peoples "normal" and WOT. but nonetheless, the turbo shouldn't have been hot enough to require a ten min cool down being as how i wasn't pulling anything and i only drove 3/4 of a mile, stopped at the store, then drove 3/4 of a mile back.
 
Dunno what caused it, but try removing power for 10-15mins to reset the computer(s)... couldnt hurt.

-j
 
Ahhh, I'm gonna venture out and say you didn't get a good install. I'd suggest uninstalling it, driving it a little, and then re-installing it. If you really want to know what to do PM Bob Wagner, and he'll tell you all about it, I'm sure... ... .
 
was the a/c on? I've noticed that the EGT will drop MUCH faster in park if I turn off the A/C...

also, where you installing the software in full sun? I've had the smarty shut down if it was not shaded and got too hot...
 
Hope you get it fixed. I am in Edmond broke down with a bad transmission. Out by frontier city.

Okie 409-771-3098 if you want to holler at me.
 
I feel your pain. I've had a new tyranny on the way from DTT now for over a month and I found out today its gonna be at least 3 more weeks and mine is slipping bad, not to mentioned. I found a piece of a wave bans in the pan last time I changed the fluid. If there's anything I can do to help just call or text me 405. 326. 8520.
Jay
 
Status
Not open for further replies.
Back
Top