Here I am

EGT "Normal" temps?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Barometric Pressure Sensor Location

Cutting sensors off

Status
Not open for further replies.
I just installed my pyro for my edge insight. I was seeing 1375@ 65-70 while pulling my 19ft ski boat to the lake today. Is this in the safe zone? how hot it too hot? i noticed that i was going through a regen also at these temps. :confused:
 
You can easily see 1,000 to 1,300+. I tow a 15,000+# fifth wheel to Colorado every summer. If you have a stock truck, the ECM won't let the truck hurt itself.

Newt
 
Last edited:
Boy I sure hope that your EGTs dont ever get to Eleven thousand degrees (11,000) you would at that temperature melt every vehicle within 3 miles.
 
Yea I knew what you ment,, The geezer behind this keybord has those moments too. My 04. 5 Dodge would easly top 1400 EGTs (bone stock condition) on a hard dry pull.
 
I see 1375 deg anytime the thing goes through re-gen. On a long pull I see similar temps and on the level with my 5w attached I see 1100 deg, frequently on the level and sometimes in a breeze 1200 or so. It's not uncommon to see these higher temps with the 6. 7 relative to the older 5. 9. My combined (gcwr) is at 23,450 lbs. (Edited) fyi
Ted
 
Last edited:
Status
Not open for further replies.
Back
Top